Direct measurement of strain distribution along a wood bond line. Part 2: Effects of adhesive penetration on strain distribution
-
Wolfgang Gindl
Abstract
The effect of adhesive penetration into wood on the distribution of strain along a mechanically strained bond line was evaluated. With this goal, spruce wood specimens were bonded with phenol-resorcinol-formaldehyde (PRF) and one-component polyurethane resin (PUR). Penetration of the adhesives into cell cavities was observed in a zone extending over several 100 μm from the bond line. Electronic speckle pattern interferometry was used to record the elastic deformations caused by mechanical tests in transverse compression. By differentiating 2D displacement maps, the strain distribution was calculated. Both adhesives provided an increase in the stiffness of the adhesive-wood interface due to penetration into cell cavities. Compression strain was much lower in the bond line area than in the wood. Shear strain was also low in the bond line and increased gradually with increasing distance. No change was observed in wood unaffected by the adhesive. The effects were more pro-nounced for PRF resin than for PUR.
References
Broughton, J.G., Hutchinson, A.R. (2001) Adhesive systems for structural connections in timber. Int. J. Adhes. Adhes.21:177–186.10.1016/S0143-7496(00)00049-XSearch in Google Scholar
Buckley, C.J., Phanopoulos, C., Khaleque, N., Engelen, N., Holwill, M.E.J., Michette, A.G. (2002) Examination of the penetration of polymeric methylene di-phenyl-di-isocyanate (pMDI) into wood structure using chemical-state X-ray microscopy. Holzforschung56:215–222.10.1515/HF.2002.035Search in Google Scholar
Collett, B.M. (1972) A review of surface and interfacial adhesion in wood science and related fields. Wood Sci. Technol.6:1–42.10.1007/BF00351806Search in Google Scholar
Dantec-Ettemeyer. ISTRA for Windows, Version 3.3.12. Dantec-Ettemeyer GmbH, Ulm, Germany, 2001.Search in Google Scholar
Davis, G. (1997) The performance of adhesive systems for structural timbers. Int. J. Adhes. Adhes.17:247–255.10.1016/S0143-7496(97)00010-9Search in Google Scholar
Gindl, W. (2001) SEM and UV-microscopic investigation of glue lines in Parallam PSL. Holz Roh- Werkstoff59:211–214.10.1007/s001070100194Search in Google Scholar
Gindl, W., Schöberl, T., Jeronimidis, G. (2004a) The interphase in phenol-formaldehyde (PF) and polymeric methylene di-phenyl-di-isocyanate (pMDI) glue lines in wood. Int. J. Adhes. Adhes.24:279–286.10.1016/j.ijadhadh.2003.10.002Search in Google Scholar
Gindl, W., Schöberl, T., Jeronimidis, G. (2004b) Corrigendum to “The interphase in phenol-formaldehyde (PF) and polymeric methylene di-phenyl-di-isocyanate (pMDI) glue lines in wood” [Int. J. Adhes. Adhes. 24:(2004) 279–286]. Int. J. Adhes. Adhes.24:535.Search in Google Scholar
Hare, D.A., Kutscha, N.P. (1974) Microscopy of eastern spruce plywood gluelines. Wood Sci.6:294–304.Search in Google Scholar
Kollmann, F.F.P. (1968) Mechanics and rheology of wood. In: Principles of Wood Science and Technology. Eds. Kollmann, F.F.P. and Côté, W.A. Springer Verlag, Berlin. pp. 292–419.10.1007/978-3-642-87928-9_7Search in Google Scholar
Müller, U., Sretenovic, A., Vincenti, A., Gindl, W. (2005) Direct measurement of strain distribution along a wood bond line – Part I: shear strain concentration in a lap joint specimen by means of electronic speckle pattern interferometry. Holzforschung, in press.10.1515/HF.2005.050Search in Google Scholar
Nearn, W.T. (1974) Application of the ultrastructure concept in industrial wood products research. Wood Sci.6:285–293.Search in Google Scholar
Pizzi, A. Advanced Wood Adhesives Technology. Marcel Dekker, New York, 1994.10.1201/9781482293548Search in Google Scholar
Sernek, M., Resnik, J., Kamke, F.A. (1999) Penetration of liquid urea-formaldehyde adhesive into beech wood. Wood Fiber Sci.31:41–48.Search in Google Scholar
Serrano, E. (2004) A numerical study of the shear-strength-predicting capabilities of test specimens for wood-adhesive bonds. Int. J. Adhes. Adhes.24:23–35.10.1016/S0143-7496(03)00096-4Search in Google Scholar
Serrano, E., Gustafsson, P.J. (1999) Influence of bondline brittleness and defects on the strength of timber finger joints. Int. J. Adhes. Adhes.19:9–17.10.1016/S0143-7496(98)00048-7Search in Google Scholar
Smith, M.J., Dai, H., Ramani, K. (2002) Wood-thermoplastic adhesive interface – method of characterization and results. Int. J. Adhes. Adhes.22:197–204.10.1016/S0143-7496(01)00055-0Search in Google Scholar
Stehr, M., Johansson, I. (2000) Weak boundary layers on wood surfaces. J. Adhes. Sci. Technol.14:1211–1224.10.1163/156856100742168Search in Google Scholar
Suchsland, O. (1958) Über das Eindringen des Leimes bei der Holzverleimung und die Bedeutung der Eindringtiefe für die Fugenfestigkeit. Holz Roh- Werkstoff16:101–108.10.1007/BF02615415Search in Google Scholar
Wake, W.C. Adhesion and the Formulation of Adhesives. Applied Science Publishers, London, 1976.Search in Google Scholar
© by Walter de Gruyter Berlin New York
Articles in the same Issue
- Molecular dynamics study of lignin constituents in water
- Oxidative cellulose degradation by cellobiose dehydrogenase from Phanerochaete chrysosporium: A model compound study
- Characterization of active oxygen species under oxygen-alkali bleaching conditions
- Erythro/threo ratio of β-O-4-5 structures as an important structural characteristic of lignin. Part 4: Variation in the erythro/threo ratio in softwood and hardwood lignins and its relation to syringyl/guaiacyl ratio
- Stereoisomers of 3,3′-dimethoxy-4,4′-stilbenequinone
- Liquefaction of CCA-treated wood and elimination of metals from the solvent by precipitation
- Condensed tannins from steamed Acacia mearnsii bark
- Chemical composition and antifungal activity of essential oil isolated from Chamaecyparis formosensis Matsum. wood
- Direct measurement of strain distribution along a wood bond line. Part 1: Shear strain concentration in a lap joint specimen by means of electronic speckle pattern interferometry
- Direct measurement of strain distribution along a wood bond line. Part 2: Effects of adhesive penetration on strain distribution
- Rate-independent mechanical behavior of biaxially stressed wood: Experimental observations and constitutive modeling as an orthotropic two-surface elasto-plastic material
- Characterization of sugar maple wood-polymer composites: Monomer retention and polymer retention
- New insights into wood and cement interaction
- Wood-water sorption isotherm prediction with artificial neural networks: A preliminary study
- Hygroscopicity of resorcinol-formaldehyde resin and aqueous vinyl polymer-isocyanate resin in high humidity
- Modelling anisotropic maturation strains in wood in relation to fibre boundary conditions, microstructure and maturation kinetics
- Properties of chemically and mechanically isolated fibres of spruce (Picea abies [L.] Karst.). Part 3: Mechanical characterisation
- Resistance of thermo-hygro-mechanically densified wood to colonisation and degradation by brown-rot fungi
- Microbial colonizers of freshly sawn yellow-poplar (Liriodendron tulipifera L.) lumber in two seasons. Part 3: Yeasts
- Efficacy of a copper(II)/oxine copper wood preservative mixture after 69 months of outdoor ground-contact exposure and a proposed mechanism to explain the observed synergism
- Differentiation of indoor wood decay fungi with MALDI-TOF mass spectrometry
- Horst H. Nimz celebrates his 75th birthday on April, 21st, 2005
- Erratum
Articles in the same Issue
- Molecular dynamics study of lignin constituents in water
- Oxidative cellulose degradation by cellobiose dehydrogenase from Phanerochaete chrysosporium: A model compound study
- Characterization of active oxygen species under oxygen-alkali bleaching conditions
- Erythro/threo ratio of β-O-4-5 structures as an important structural characteristic of lignin. Part 4: Variation in the erythro/threo ratio in softwood and hardwood lignins and its relation to syringyl/guaiacyl ratio
- Stereoisomers of 3,3′-dimethoxy-4,4′-stilbenequinone
- Liquefaction of CCA-treated wood and elimination of metals from the solvent by precipitation
- Condensed tannins from steamed Acacia mearnsii bark
- Chemical composition and antifungal activity of essential oil isolated from Chamaecyparis formosensis Matsum. wood
- Direct measurement of strain distribution along a wood bond line. Part 1: Shear strain concentration in a lap joint specimen by means of electronic speckle pattern interferometry
- Direct measurement of strain distribution along a wood bond line. Part 2: Effects of adhesive penetration on strain distribution
- Rate-independent mechanical behavior of biaxially stressed wood: Experimental observations and constitutive modeling as an orthotropic two-surface elasto-plastic material
- Characterization of sugar maple wood-polymer composites: Monomer retention and polymer retention
- New insights into wood and cement interaction
- Wood-water sorption isotherm prediction with artificial neural networks: A preliminary study
- Hygroscopicity of resorcinol-formaldehyde resin and aqueous vinyl polymer-isocyanate resin in high humidity
- Modelling anisotropic maturation strains in wood in relation to fibre boundary conditions, microstructure and maturation kinetics
- Properties of chemically and mechanically isolated fibres of spruce (Picea abies [L.] Karst.). Part 3: Mechanical characterisation
- Resistance of thermo-hygro-mechanically densified wood to colonisation and degradation by brown-rot fungi
- Microbial colonizers of freshly sawn yellow-poplar (Liriodendron tulipifera L.) lumber in two seasons. Part 3: Yeasts
- Efficacy of a copper(II)/oxine copper wood preservative mixture after 69 months of outdoor ground-contact exposure and a proposed mechanism to explain the observed synergism
- Differentiation of indoor wood decay fungi with MALDI-TOF mass spectrometry
- Horst H. Nimz celebrates his 75th birthday on April, 21st, 2005
- Erratum
