Changes of EPR Spectra of Wood Impregnated with Copper-Based Preservatives during Exposure to Several Wood-Rotting Fungi
-
M. Humar
, M. Petrič , F. Pohleven , M. Šentjurc and P. Kalan
Summary
The tolerance of various fungi against copper was examined. For this purpose, we impregnated Norway spruce (Picea abies) specimens with two different aqueous solutions: copper(II) octanoate with ethanolamine or copper(II) sulfate (cCu = 1.0 × 10−2 mol/l). Impregnated and unimpregnated test specimens were then exposed to brown rot fungi Antrodia vaillantii and Gloeophyllum trabeum or to white-rot fungi Schizophyllum commune and Trametes versicolor. After 2, 4, 6 and 12 weeks of exposure Electron Paramagnetic Resonance, Atomic Absorption Spectroscopy and mass loss measurements were performed. The results indicate that A. vaillantii, G. trabeum and T. versicolor transform copper(II) sulfate in wood into non-soluble, and therefore non-toxic, copper oxalate. The intensity of this reaction depends on the amount of excreted oxalic acid and was the highest for A. vaillantii and the lowest for T. versicolor. In the presence of ethanolamine, formation of insoluble copper oxalate was not possible and therefore, decay could not proceed. The major portion of copper remained in the wood and only minor amounts were in some cases translocated into nutrient media.
Copyright © 2002 by Walter de Gruyter GmbH & Co. KG
Articles in the same Issue
- Weight Loss and Cell Wall Degradation in Rubberwood Caused by Sapstain Fungus Botryodiplodia theobromae
- Changes of EPR Spectra of Wood Impregnated with Copper-Based Preservatives during Exposure to Several Wood-Rotting Fungi
- Quantitative Analyses of Morphological Variation of Cross-Sectional Tracheids of Hinoki (Chamaecyparis obtusa Endl.) Near Knot by Image Processing
- Direct Effects of Wood Characteristics on Pulp and Handsheet Properties of Eucalyptus globulus
- Identification of the Lignan Nortrachelogenin in Knot and Branch Heartwood of Scots Pine (Pinus sylvestris L.)
- Chemical Composition of Lipophilic and Phenolic Constituents of Barks from Pinus nigra, Abies bornmülleriana and Castanea sativa
- Pinus pinaster Oleoresin in Plus Trees
- Determination of Polyphenolic Content of Bark Extracts for Wood Adhesives
- Softwood Bark Pyrolysis Oil-PF Resols. Part 2. Thermal Analysis by DSC and TG
- Softwood Bark Pyrolysis Oil-PF Resols. Part 3. Use of Propylene Carbonate as Resin Cure Accelerator
- Steam Explosion of Aspen Wood. Characterisation of Reaction Products
- Characterization of Black Liquors from Soda-AQ Pulping of Reed Canary Grass (Phalaris arundinacea L.)
- Modification of the Nitrogen Content and C:N Ratio of Sitka Spruce Timber by Kiln and Air Drying
- High Resolution Measurement of the Surface Layer Moisture Content during Drying of Wood Using a Novel Magnetic Resonance Imaging Technique
- Longitudinal Permeability and Diffusivity of Steam in Beech Determined with a Wicke-Kallenbach-Cell
- UF/pMDI Wood Adhesives: Networks Blend versus Copolymerization
Articles in the same Issue
- Weight Loss and Cell Wall Degradation in Rubberwood Caused by Sapstain Fungus Botryodiplodia theobromae
- Changes of EPR Spectra of Wood Impregnated with Copper-Based Preservatives during Exposure to Several Wood-Rotting Fungi
- Quantitative Analyses of Morphological Variation of Cross-Sectional Tracheids of Hinoki (Chamaecyparis obtusa Endl.) Near Knot by Image Processing
- Direct Effects of Wood Characteristics on Pulp and Handsheet Properties of Eucalyptus globulus
- Identification of the Lignan Nortrachelogenin in Knot and Branch Heartwood of Scots Pine (Pinus sylvestris L.)
- Chemical Composition of Lipophilic and Phenolic Constituents of Barks from Pinus nigra, Abies bornmülleriana and Castanea sativa
- Pinus pinaster Oleoresin in Plus Trees
- Determination of Polyphenolic Content of Bark Extracts for Wood Adhesives
- Softwood Bark Pyrolysis Oil-PF Resols. Part 2. Thermal Analysis by DSC and TG
- Softwood Bark Pyrolysis Oil-PF Resols. Part 3. Use of Propylene Carbonate as Resin Cure Accelerator
- Steam Explosion of Aspen Wood. Characterisation of Reaction Products
- Characterization of Black Liquors from Soda-AQ Pulping of Reed Canary Grass (Phalaris arundinacea L.)
- Modification of the Nitrogen Content and C:N Ratio of Sitka Spruce Timber by Kiln and Air Drying
- High Resolution Measurement of the Surface Layer Moisture Content during Drying of Wood Using a Novel Magnetic Resonance Imaging Technique
- Longitudinal Permeability and Diffusivity of Steam in Beech Determined with a Wicke-Kallenbach-Cell
- UF/pMDI Wood Adhesives: Networks Blend versus Copolymerization