Acetyl Group Distribution in Acetylated Wood Investigated by Microautoradiography
-
Marie Rosenqvist
Summary
Sapwood of Scots pine (Pinus silvestris L.) was acetylated with 14C- and 3H-labelled acetic anhydride. The distribution of acetyl groups was investigated with microautoradiography and microautoradiographs were evaluated with ESEM, Environmental Scanning Electron Microscopy.
The investigation showed that the impregnation of wood with radioisotope-labelled substances provides a good opportunity to investigate the location of substances covalently bonded to the wood material. Introduced 14C-labelled acetyl groups show an even distribution in the wood cell wall, with no discernible concentration gradients at acetylation levels of about 5, 15 and 20% weight gain. 3H-labelled acetyl groups show an even distribution in the wood cell wall at 15 and 20% weight gain, with no discernible concentration gradients. At the 5% weight gain level, however, an uneven distribution of 3H-labelled acetyl groups over the cell wall is observed. Nevertheless, the unevenness is random and no concentration gradient is discernible at this level.
3H with a relatively high resolution, 0.5–1 μm, compared to 14C with a resolution of 2–5 μm, gives more accurate information about where exactly the acetyl groups are situated in the wood cell wall. Acetic anhydride was evenly distributed when a full impregnation procedure was used. The chemical and physical properties of acetic anhydride allow a uniform penetration into the pine cell wall and a complete acetylation takes place when the specimens are heated.
Copyright © 2001 by Walter de Gruyter GmbH & Co. KG
Articles in the same Issue
- Characterisation of Fungal Degraded Birch Wood by FTIR and Py-GC
- The Effects of Specific Volatile Organic Compounds Produced by Trichoderma Spp. on the Growth of Wood Decay Basidiomycetes
- Biological Control of Blue Stain in Pulpwood: Mechanisms of Control used by Phlebiopsis gigantea
- Cell-Wall-Associated Peroxidases from the Lignifying Xylem of Angiosperms and Gymnosperms: Monolignol Oxidation
- Laboratory Evaluation of Natural Decay Resistance and Efficacy of CCA-Treated Rubberwood (Hevea brasiliensis Muell. Arg.)
- Inhibition of the Photodiscoloration of Wood by Butyrylation
- Lipophilic Extractives from Eucalyptus globulus Pulp during Kraft Cooking Followed by TCF and ECF Bleaching
- Determination of Monosaccharide Composition of Eucalyptus globulus Wood by FTIR Spectroscopy
- Acetyl Group Distribution in Acetylated Wood Investigated by Microautoradiography
- Solid State NMR Analysis of β-13C-Enriched Lignocellulosic Material During Light-Induced Yellowing
- N-Hydroxy Compounds as New Internal Standards for the 31P-NMR Determination of Lignin Hydroxy Functional Groups
- 19F NMR Spectroscopy for the Quantitative Analysis of Carbonyl Groups in Lignins
- Reactions of the β-Aryl Ether Lignin Model 1-(4-Hydroxy-3-Methoxyphenyl)-2-(2-Methoxyphenoxy)-1-Propanol on Heating in Aqueous Solution
- Structural Analysis of Residual and Technical Lignins by 1H-13C Correlation 2D NMR-Spectroscopy
- Experimental Determination of Stiffness Variation Across Growth Rings in Picea abies
- Determination of the Material Property Variations Across the Growth Ring of Softwood for Use in a Heterogeneous Drying Model Part 1. Capillary Pressure,Tracheid Model and Absolute Permeability
- Surface Area Determinations in Woodpulps by Humidity Adsorption
- A Simple Testing Method for the Measurement of the Water Vapour Transmission of Coated Wood Longitudinal and Tangential to Grain Direction
- Literature Reports
Articles in the same Issue
- Characterisation of Fungal Degraded Birch Wood by FTIR and Py-GC
- The Effects of Specific Volatile Organic Compounds Produced by Trichoderma Spp. on the Growth of Wood Decay Basidiomycetes
- Biological Control of Blue Stain in Pulpwood: Mechanisms of Control used by Phlebiopsis gigantea
- Cell-Wall-Associated Peroxidases from the Lignifying Xylem of Angiosperms and Gymnosperms: Monolignol Oxidation
- Laboratory Evaluation of Natural Decay Resistance and Efficacy of CCA-Treated Rubberwood (Hevea brasiliensis Muell. Arg.)
- Inhibition of the Photodiscoloration of Wood by Butyrylation
- Lipophilic Extractives from Eucalyptus globulus Pulp during Kraft Cooking Followed by TCF and ECF Bleaching
- Determination of Monosaccharide Composition of Eucalyptus globulus Wood by FTIR Spectroscopy
- Acetyl Group Distribution in Acetylated Wood Investigated by Microautoradiography
- Solid State NMR Analysis of β-13C-Enriched Lignocellulosic Material During Light-Induced Yellowing
- N-Hydroxy Compounds as New Internal Standards for the 31P-NMR Determination of Lignin Hydroxy Functional Groups
- 19F NMR Spectroscopy for the Quantitative Analysis of Carbonyl Groups in Lignins
- Reactions of the β-Aryl Ether Lignin Model 1-(4-Hydroxy-3-Methoxyphenyl)-2-(2-Methoxyphenoxy)-1-Propanol on Heating in Aqueous Solution
- Structural Analysis of Residual and Technical Lignins by 1H-13C Correlation 2D NMR-Spectroscopy
- Experimental Determination of Stiffness Variation Across Growth Rings in Picea abies
- Determination of the Material Property Variations Across the Growth Ring of Softwood for Use in a Heterogeneous Drying Model Part 1. Capillary Pressure,Tracheid Model and Absolute Permeability
- Surface Area Determinations in Woodpulps by Humidity Adsorption
- A Simple Testing Method for the Measurement of the Water Vapour Transmission of Coated Wood Longitudinal and Tangential to Grain Direction
- Literature Reports
