Modelling of forming and densification of fibre mats in twin-wire formers

Articles in the same Issue

1. The fate of chlorine species during high temperature chlorine dioxide bleaching
2. Preparation of brightness sheets (ISO 3688:1999) – Problems and proposed modifications
3. Modelling of forming and densification of fibre mats in twin-wire formers
4. The stress-strain relationship of the fibre network in wet pressing
5. Application of a pitometer to measure the tangential velocity in a cylindrical through-flow hydrocyclone operated with a fiber suspension
6. Influence of polyelectrolyte complexes on the strength properties of papers from unbleached kraft pulps with different yields
7. Dimensional consistency of wood chips over time
8. Extensional rheology of coating suspensions in relation with misting in film coaters
9. Further insight in the web consolidation process Part II. Triangular phase diagrams for analysis of paper shrinkage
10. Further insight in the web consolidation process Part III. Modelling of paper shrinkage
11. Quantification of dislocations in spruce pulp and hemp fibres using polarized light microscopy and image analysis
12. Water-induced surface roughness of offset papers
13. Simulation and measurement of velocity and concentration of dry wood fibres flowing through a throttle
14. Condebelt drying and linerboard performance
15. Second-law analysis applied to a kraft pulp mill
16. Process efficiency with entropy – The recovery cycle in the kraft pulp process
17. Surface characterisation of single fibres from mechanical pulps by contact angle measurements
18. Characterization of industrial and laboratory pulp fibres using HCl, Cellulase and FiberMaster analysis
19. Doctorial dissertations in the field of pulp and paper science and technology 2004
20. ANNUAL INDEX FOR 2006