Home Effect of hydroxide and sulfite ion concentration in alkaline sulfite anthraquinone (ASA) pulping – a comparative study
Article
Licensed
Unlicensed Requires Authentication

Effect of hydroxide and sulfite ion concentration in alkaline sulfite anthraquinone (ASA) pulping – a comparative study

  • Markus Paananen EMAIL logo , Stella Rovio , Tiina Liitiä and Herbert Sixta EMAIL logo
Published/Copyright: March 18, 2015
Become an author with De Gruyter Brill

Abstract

Pulp and black liquor produced by alkaline sulfite anthraquinone (ASA) process were comprehensively characterized to evaluate the effects of ion concentration on the delignification and polysaccharide preservation. Scots pine wood meal was pulped at 160°C with a sulfite-to-hydroxide ion ratio of 0.75 and liquor-to-wood ratio of 200:1. Two concentration levels were studied in presence and absence of anthraquinone (AQ). Contrary to the expectations, already the lower concentration level (L-ASA) revealed rapid delignification in presence of AQ, while only moderate acceleration was obtained at the high concentration level (H-ASA). However, H-ASA liquor resulted in a slightly higher pulp yield of 1–2% (based on wood) but only in case of pulps with kappa numbers (KN) above 60. With progressing delignification, the yield advantage was gradually lost. The higher pulp yield at H-ASA conditions was mainly due to improved galactoglucomannan retention, which was around 2% on KN60 pulp and around 0.5% after prolonged delignification. The xylan content, on the other hand, was found to be 1% (based on wood) lower under H-ASA conditions compared to L-ASA conditions, which may be attributed to an increased solubility of short-chain polysaccharides at high alkali concentration.


Corresponding authors: Markus Paananen and Herbert Sixta, Department of Forest Products Technology, School of Chemical Technology, Aalto University, Vuorimiehentie 1, FI-00076 Finland, e-mail: ,

Acknowledgments

The authors would like to acknowledge the Finnish Funding Agency for Technology and Innovation (Tekes) and FIBIC Ltd. for financial support.

References

Al-Dajani, W., Tschirner, U. (2010) Pre-extraction of hemicelluloses and subsequent ASA and ASAM pulping: comparison of autohydrolysis and alkaline extraction. Holzforschung 64:411–416.10.1515/hf.2010.064Search in Google Scholar

Dahlbom, J., Olm, L., Teder, A. (1990) The characteristics of MSS-AQ pulping – a new pulping process. Tappi J. 73:257–261.Search in Google Scholar

Fengel, D., Wegener, G. (1989) Lignin. In: Wood – Chemistry, Ultrastructure, Reactions. De Gruyter, Berlin. pp. 132–181.Search in Google Scholar

Gellerstedt, G. (1976) The reactions of lignin during sulfite pulping. Svensk Papperstidn. 79:537–543.Search in Google Scholar

Ingruber, O. (1985a) Part 1: sulfite science. In: Pulp and Paper Manufacture: Volume 4. Sulfite Science & Technology. Eds. Ingruber, O., Kocurek, M., Wong, A. Canadian Pulp and Paper Association, Montreal, Canada. pp. 1–49.Search in Google Scholar

Ingruber, O. (1985b) Alkaline sulfite anthraquinone pulping – a brief review of its nature, development and present status. Proceedings in the TAPPI Pulping Conference, 461–469.Search in Google Scholar

Ingruber, O., Stradal, M., Histed, J.A. (1982) Alkaline sulphite-anthraquinone pulping of eastern Canadian woods. Pulp Pap. Canada 83:79–88.Search in Google Scholar

Janson, J. (1970) Calculation of polysaccharide composition of wood and pulp. Pap. Puu 52:323–329.Search in Google Scholar

MacLeod, J.M. (1986) Alkaline sulfite-anthraquinone pulp from aspen. Tappi J. 69:106–109.Search in Google Scholar

McDonough, T.J., van Drunen, V.J., Paulson, T.W. (1985) Sulphite-anthraquinone pulping of southern pine for bleachable grades. J. Pulp Pap. Sci. 11:167–176.Search in Google Scholar

Olm, L., Teder, A. (1986) MSS-AQ – Ny kokprocess: Bättre utbyte – mindre blekmedel – mindre lukt. Svensk Papperstidn. 89:20–22.Search in Google Scholar

Paananen, M., Tamminen, T., Nieminen, K., Sixta, H. (2010) Galactoglucomannan stabilization during the initial kraft cooking of Scots pine. Holzforschung 64:683–692.10.1515/hf.2010.109Search in Google Scholar

Paananen, M., Liitiä, T., Sixta, H. (2013) Further insight into carbohydrate degradation and dissolution behavior during kraft cooking under elevated alkalinity without and in the presence of anthraquinone. Ind. Eng. Chem. Res. J. 52:12777–12784.10.1021/ie4018012Search in Google Scholar

Patt, R., Knoblauch, J., Faix, O., Kordsachia, O., Puls, J. (1991) Lignin and carbohydrate reactions in alkaline sulfite, anthraquinone, methanol (ASAM) pulping. Das Papier 45:389–396.Search in Google Scholar

Patt, R., Kordsachia, O. (2001) Development in pulping and bleaching. In proceedings of 6th Brazilian Symposium on the Chemistry of Lignins and Other Wood Components, Guaratingueta, Brazil, vol. 7, 61–70.Search in Google Scholar

Patt, R., Kordsachia, O., Rose, R. (2003) Modifizierter alkalischer Sulfitaufschluss. Wochenblatt für Papierfabrikation 131:892–897.Search in Google Scholar

Pereira, M., Kordsachia, O., Patt, R. (2007) ASA and kraft pulping of Eucalyptus globulus and Eucalyptus nitens. Professional Papermaking 4:44–49.Search in Google Scholar

Samp, J.C. (2008) A comprehensive mechanism for anthraquinone mass transfer in alkaline pulping. Doctoral thesis, School of Chemical and Biomolecular Engineering, Georgia Institute of Technology.Search in Google Scholar

Sixta, H. (1998) Comparative evaluation of different concepts of sulfite pulping technology. Lenzinger Berichte 78:18–27.Search in Google Scholar

Sjöström, E. (1977) The behavior of wood polysaccharides during alkaline pulping process. Tappi J. 60:151–157.Search in Google Scholar

Sluiter, A., Hames, B., Ruiz, R., Scarlata, C., Sluiter, B., Templeton, D., Crocker, D. (2008) Determination of structural carbohydrates and lignin in biomass. Technical Report NREL/TP-510-42618.Search in Google Scholar

Swan, B. (1965) Isolation of acid-soluble lignin from the Klason lignin determination. Svensk Papperstidn. 68:791–795.Search in Google Scholar

Tasman, J.E. (1959) The permanganate consumption of pulp materials. IV. The KAPPA correction coefficient. Pulp Pap. Canada 60:231–235.Search in Google Scholar

Vroom, K.E. (1957) The “H” factor: a means of expressing cooking times and temperature as a single variable. Pulp Paper Mag. Canada 58:228–231.Search in Google Scholar

Young, R.A., Sarkanen, K.V., Johnson, P.G., Allan, G.G. (1972) A kinetic analysis of the alkaline degradation of polysaccharides with specific reference to 1-3 linked β-d-glucans. Carbohydr. Res. 21:111–122.10.1016/S0008-6215(00)81736-XSearch in Google Scholar

Young, R.A., Liss, L. (1978) A kinetic study of the alkaline endwise degradation of gluco- and galactomannans. Cellul. Chem. Technol. 12:399–411.Search in Google Scholar

Received: 2014-10-13
Accepted: 2015-2-17
Published Online: 2015-3-18
Published in Print: 2015-8-1

©2015 by De Gruyter

Articles in the same Issue

  1. Frontmatter
  2. Effect of hydroxide and sulfite ion concentration in alkaline sulfite anthraquinone (ASA) pulping – a comparative study
  3. Novel insight in carbohydrate degradation during alkaline treatment
  4. Activated hydrogen peroxide decolorization of a model azo dye-colored pulp
  5. Effects of inorganic salts on the degradation of 2,5-dihydroxy-[1,4]-benzoquinone as a key chromophore in pulps by hydrogen peroxide under basic conditions
  6. Analysis of degradation products in rayon spinning baths
  7. Effect of cellulase-assisted refining on the thermal degradation of bleached high-density paper
  8. Synthesis and characterization of functionalized 4-O-methylglucuronoxylan derivatives
  9. Hydrophobic materials based on cotton linter cellulose and an epoxy-activated polyester derived from a suberin monomer
  10. Depolymerization of cellulose during cold acidic chlorite treatment
  11. Enhanced stability of PVA electrospun fibers in water by adding cellulose nanocrystals
  12. Micro-nanoparticle gels obtained from bark for their use alone and with chitosan and Na-CMC in paper coatings
  13. Conversion of sulfur-free black liquor into fuel gas by supercritical water gasification
  14. Modification of acid hydrolysis lignin for value-added applications by micronization followed by hydrothermal alkaline treatment
  15. Preparation of lignin-containing porous microspheres through the copolymerization of lignin acrylate derivatives with styrene and divinylbenzene
  16. Wood-based activated carbons for supercapacitors with organic electrolyte
  17. Functionality and physico-chemical characteristics of wheat straw lignin, Biolignin™, derivatives formed in the oxypropylation process
  18. Antioxidant activity of various lignins and lignin-related phenylpropanoid units with high and low molecular weight
  19. Characterization of technical lignins by NMR spectroscopy: optimization of functional group analysis by 31P NMR spectroscopy
  20. Chemical composition of volatiles extracted from indigenous tree species of Uganda: composition of bark extracts from Psorospermum febrifugum and Milicia excelsa
Downloaded on 5.9.2025 from https://www.degruyterbrill.com/document/doi/10.1515/hf-2014-0303/html
Scroll to top button