Home Convective Mass Transfer Coefficient at Wooden Surface in Jet Drying of Veneer
Article
Licensed
Unlicensed Requires Authentication

Convective Mass Transfer Coefficient at Wooden Surface in Jet Drying of Veneer

  • Antti Hukka and Olli Oksanen
Published/Copyright: June 1, 2005
Become an author with De Gruyter Brill
Holzforschung
From the journal Volume 53 Issue 2

Summary

The relationship between heat and mass transfer at wooden surface is investigated experimentally by drying 1.6 mm thick birch veneers in constant conditions in a laboratory-scale roller dryer. By intermediate weighing of the samples a drying curve is established for each specimen. The drying curves are formulated in a functional form to produce the drying rate as a function of wood moisture content. Based on that and the measured heat-transfer coefficient a correction factor is calculated for the mass transfer coefficient predicted by the boundary layer theory.

The results show that the convective mass transfer coefficient for wooden surfaces substantially deviates from that given by the analogy between heat and mass transfer. The correction factor describing the internal resistance for evaporation is strongly dependent on wood temperature within the range 50–90°C, but for practical purposes not dependent on the average moisture content of the veneer (range 40–70%). The numerical value of the correction coefficient established is somewhat lower than published earlier by other researchers.

:
Published Online: 2005-06-01
Published in Print: 1999-03-01

Copyright (c)1999 by Walter de Gruyter GmbH & Co. KG

Articles in the same Issue

  1. Electron Energy Loss Spectroscopy (EELS) for Quantification of Cell-Wall Penetration of a Melamine Resin
  2. Extraction Conditions Affect Protein Recovery and Enzyme Activity in Wood Wafers Exposed to Stain Fungi and Bioprotectants
  3. Identification of the Dry Rot Fungus, Serpula lacrymans, and the Wild Merulius, S. himantioides, by Amplified Ribosomal DNA Restriction Analysis (ARDRA)
  4. Development of Model Systems for Investigations of the Dry Rot Fungus Serpula lacrymans (Schumach. ex Fr.) Gray: Use for Analysis of the Environmental Sensitivity of the Organism
  5. Extracellular Polysaccharides from the Suspension-Culture of <I>Populus Alba</I> L.
  6. Chemical Constituents and Mechanisms of Discoloration of Taiwania (Taiwania cryptomerioides Hayata) Heartwood. The Structure Reconfirmation and Conversion Mechanism of Taiwanin A
  7. Ellagitannins in Woods of Spanish, French and American Oaks
  8. Water Repellent Efficiency of Organic Solvent Extractives from Aleppo Pine Leaves and Bark Applied to Wood
  9. Deposition of Lignin in Differentiating Xylem Cell Walls of Normal and Compression Wood of Buxus microphylla var. insularis Nakai
  10. Depolymerization of Straw Lignin by Manganese Peroxidase from Nematoloma frowardii is Accompanied by Release of Carbon Dioxide
  11. Structural Characterization of Cork Lignin by Thioacidolysis and Permanganate Oxidation
  12. The Reaction of Phenolic Model Compounds in the Laccase-Mediator System (LMS) Investigations by Matrix Assisted Laser Desorption Ionization Time-of-Flight Mass Spectrometry (MALDI-TOF-MS)
  13. Use of an Improved Chemiluminescence Assay for Non-Intrusive Measurement of Hydroxyl Radicals in a Biomimetic Pulp Bleaching Model System
  14. Surface Composition and Morphology of CTMP Fibers
  15. Reactivity of Radiata Pine Sapwood Towards Carboxylic Acid Anhydrides
  16. Influence of Growth Rate and Cambial Age on Density of Rauli (Nothofagus nervosa) in Relation to Vessel Lumen Areas and Numbers
  17. Convective Mass Transfer Coefficient at Wooden Surface in Jet Drying of Veneer
  18. Tangential Youngs Modulus of Coniferous Early Wood Investigated Using Cell Models
  19. Effect of Silvicultural Practice and Wood Type on Loblolly Pine Particleboard and Medium Density Fiberboard Properties
  20. Literature Report
Downloaded on 26.10.2025 from https://www.degruyterbrill.com/document/doi/10.1515/HF.1999.034/html
Scroll to top button