Third in a Series: Pioneers of Polymer Processing: Charles Goodyear

Artikel in diesem Heft

1. Contents
2. Contents
3. Editorial
4. Third in a Series: Pioneers of Polymer Processing: Charles Goodyear
5. Screw Extrusion/Mixing
6. Chaotic Features of Flow in Polymer Processing Equipment-Relevance to Distributive Mixing
7. Influence of Design on Mixing Efficiency in a Variable Intermeshing Clearance Mixer
8. Simulation of Non-Isothermal Flow in a Modular Buss Kneader and Comparison with Experiment
9. Rheological Behaviour of LLDPE/LDPE Blends under Elongational Deformation
10. Effect of Compounding Conditions on Mechanical Properties of Glass Fiber-Reinforced Polyamide-6
11. Die Extrusion
12. A New Approach to Simulation of Die Flow which Incorporates the Extruder and Rotating Screw Tips in the Analysis
13. New Aspects Concerning the Design of Coathanger Dies
14. Film
15. On-Line Birefringence Measurement in Film Blowing of a Linear Low Density Polyethylene
16. Brittle Melt Rupture Phenomena in Polymer Processing
17. Moulding
18. Injection Molding of LDPE/BaSO₄ Blends
19. An Experimental Study of Rotational Molding of Polypropylene/Polyethylene Copolymers
20. Determination of the Inter-Relationships Between Processing Conditions and Properties of an Injection Molded Silicone Ring Using an Experimental Design
21. Numerical Simulation of the Flow and Fiber Orientation in Reinforced Thermoplastic Injection Molded Products
22. Wide-Angle X-Ray, Densitometric and Microscopical Studies on Injection Molded Polypropylene Disks