Article
Licensed
Unlicensed
Requires Authentication
Material Flow During Compression Moldings of Long Fiber Reinforced Thermoplastic Composites
-
H. Harnada
Published/Copyright:
May 27, 2013
Abstract
Because of their many advantages, long fiber reinforced thermoplastic composites have been used in many industrial applications. However, because material flows during compression molding cause a large scatter in the mechanical properties of moldings, it is necessary to characterize the flow behavior during molding. A new experimental procedure, the “Mark Method”, was used to observe the flow in different layers during molding. Mold flow was found to be characterized by interlaminar slippage, which causes the core layer to flow to the edge of the panel.
Received: 1992-7-8
Accepted: 1992-11-24
Published Online: 2013-05-27
Published in Print: 1993-09-01
© 1993, Carl Hanser Verlag, Munich
You are currently not able to access this content.
You are currently not able to access this content.
Articles in the same Issue
- Contents
- Contents
- Mixing
- Processing-Structure-Properties Relationships in Blends with Thermotropic Liquid Crystalline Polymers
- Screw Extrusion
- Extrusion of Recycled Polymer Feedstocks
- A Unified View of Modeling Flow in Counter-rotating Twin Screw Extruders
- Experimental Study on Dewatering and Devolatilizing Operations Using Intermeshed Twin Screw Extruders
- Molding
- Simulation of Injection Molding and Comparison with Experimental Values
- On the Kinetics of Shear Induced Crystallization in Polypropylene
- Structures and Properties of Injection Moldings of Glass Fiber-filled Polypropylenes
- Detailed Investigations of Structural Layering Phenomena in Injection Molded Thermotropic Liquid Crystalline Polymers
- Material Flow During Compression Moldings of Long Fiber Reinforced Thermoplastic Composites
- Rapid Communication of Recent Advances
- Dimensional Control of Multicomponent Extrusion
Articles in the same Issue
- Contents
- Contents
- Mixing
- Processing-Structure-Properties Relationships in Blends with Thermotropic Liquid Crystalline Polymers
- Screw Extrusion
- Extrusion of Recycled Polymer Feedstocks
- A Unified View of Modeling Flow in Counter-rotating Twin Screw Extruders
- Experimental Study on Dewatering and Devolatilizing Operations Using Intermeshed Twin Screw Extruders
- Molding
- Simulation of Injection Molding and Comparison with Experimental Values
- On the Kinetics of Shear Induced Crystallization in Polypropylene
- Structures and Properties of Injection Moldings of Glass Fiber-filled Polypropylenes
- Detailed Investigations of Structural Layering Phenomena in Injection Molded Thermotropic Liquid Crystalline Polymers
- Material Flow During Compression Moldings of Long Fiber Reinforced Thermoplastic Composites
- Rapid Communication of Recent Advances
- Dimensional Control of Multicomponent Extrusion
