Contents

Articles in the same Issue

1. Contents
2. Contents
3. Original Contributions
4. Prediction of Birefringence for Optical Memory Disk
5. Transient Compressible Flow in Injection Molding Runner**
6. Advances in Rheological Analysis of Injection Molding
7. Optical and Mechanical Measurements to Characterize Injection Molded Polypropylene Plates
8. Experimental Investigation of Rotational Molding and the Characterization of Rotationally Molded Polyethylene-Parts
9. Blow Molding of Thermotropic Liquid Crystalline Polymers
10. Position of Neutral Surface during Hollow Disk Compression Molding of Long Fibre-Reinforced Thermoplastics**
11. Reactive Ion Etching of Polymer Films
12. Fabrication of Microstructures of Extreme Structural Heights by Reaction Injection Molding
13. Rheological Properties of Glass Fiber Filled Nylon 6 Composite System