Article
Licensed
Unlicensed
Requires Authentication
Tensile Strength Characteristics of Polymer Melts
-
M. Zatloukal
Published/Copyright:
June 5, 2013
Abstract
Two different methodologies were employed to determine tensile strength properties of two LDPEs and two metallocene LLDPE resins through capillary and Haul-off (Rheotens-like) measurements. It has been shown that the tensile strength properties obtained by both methods yield almost the same values. Moreover, these values can be correlated to the drawability in tubular film blowing for corresponding materials.
Received: 2002-2-12
Accepted: 2002-7-1
Published Online: 2013-06-05
Published in Print: 2002-09-01
© 2002, Carl Hanser Verlag, Munich
You are currently not able to access this content.
You are currently not able to access this content.
Articles in the same Issue
- Editorial
- Touchstones of Polymer Processing
- Twin Screw Extrusion and Compounding
- Residence Time Distribution Curves of Screw Elements in Twin-Srew Extruder
- Rheological Effect of Zinc Surfactant on the TESPT-Silica Mixture in NR and S-SBR Compounds
- Optimization of Processing Conditions for Polymer Twin-Screw Extrusion
- Fibers and Film
- The Prediction of Sharkskin Instability Observed during Film Blowing
- Tensile Strength Characteristics of Polymer Melts
- Biaxially Oriented PP Films Using the Double Bubble Process
- Fiber and Film
- Crystallization and Orientation Development in Melt Spinning Isotactic PP of Varying Tacticity
- Extrusion Coating
- Extrusion Coating with Metallocene-Catalysed Polyethylenes
- Injection Molding
- Design Sensitivity Analysis Applied to Injection Molding for Optimization of Gate Location and Injection Pressure
- Three-dimensional Numerical Modeling of Co-injection Molding
- Residual Stress and Warpage Models for Complex Injection Molded Parts
- Blow Molding
- Investigation of Design Parameters and Novel Design of Petaloid PET Bottles
Articles in the same Issue
- Editorial
- Touchstones of Polymer Processing
- Twin Screw Extrusion and Compounding
- Residence Time Distribution Curves of Screw Elements in Twin-Srew Extruder
- Rheological Effect of Zinc Surfactant on the TESPT-Silica Mixture in NR and S-SBR Compounds
- Optimization of Processing Conditions for Polymer Twin-Screw Extrusion
- Fibers and Film
- The Prediction of Sharkskin Instability Observed during Film Blowing
- Tensile Strength Characteristics of Polymer Melts
- Biaxially Oriented PP Films Using the Double Bubble Process
- Fiber and Film
- Crystallization and Orientation Development in Melt Spinning Isotactic PP of Varying Tacticity
- Extrusion Coating
- Extrusion Coating with Metallocene-Catalysed Polyethylenes
- Injection Molding
- Design Sensitivity Analysis Applied to Injection Molding for Optimization of Gate Location and Injection Pressure
- Three-dimensional Numerical Modeling of Co-injection Molding
- Residual Stress and Warpage Models for Complex Injection Molded Parts
- Blow Molding
- Investigation of Design Parameters and Novel Design of Petaloid PET Bottles