Article
Licensed
Unlicensed
Requires Authentication
Wire Coating by Drawdown of an Extruded Annular Melt
-
Published/Copyright:
June 6, 2013
Abstract
An analytical solution is presented for wire coating by drawdown of an extruded annular melt. The solution is developed with the assumption that the pressures inside and outside the film are equal; a process in which these pressures differ, such as a vacuum inside the film, is treated as a limiting case.
Received: 1998-11-10
Accepted: 1999-3-17
Published Online: 2013-06-06
Published in Print: 1999-05-01
© 1999, Carl Hanser Verlag, Munich
You are currently not able to access this content.
You are currently not able to access this content.
Articles in the same Issue
- Editorial
- First of a Series: Pioneering Polymer Industry Developments: Bayer and the First Synthetic RubberFirst of a Series
- Internal Mixer
- Modeling Non-isothermal Mixing in a Rotor Mixer
- Screw Extrusion/Mixing
- Chrome Nitride Coatings for Applications in Plastics Processing
- Using Computational Fluid Dynamics to Investigate the Flow of a Viscous Fluid in a Cavity with Oscillating Boundaries
- Simulation of Flow in an Intermeshing Modular Counter-rotating Twin Screw Extruder: Non-Newtonian and Non-Isothermal Behavior
- Reactive Extrusion
- Bulk and Dispersed Phase Polymerization of Urethane in Twin Screw Extruders
- Die Extrusion
- Wire Coating by Drawdown of an Extruded Annular Melt
- Fibers and Films
- Structure Development in Melt Spinning Polypropylene-EPM Blends and Dynamically Vulcanized Polyolefin TPEs
- Simulation of Blown-Film Process Taking Account of Cooling-air Effect
- Molding
- Analysis of Shrinkage Development of Injection Moulded PS Samples
- Optimization of the Weldline Strength in Gas-assist Injection Molded Thermoplastic
- Injection Velocity Control Using A Self-tuning Adaptive Controller
Articles in the same Issue
- Editorial
- First of a Series: Pioneering Polymer Industry Developments: Bayer and the First Synthetic RubberFirst of a Series
- Internal Mixer
- Modeling Non-isothermal Mixing in a Rotor Mixer
- Screw Extrusion/Mixing
- Chrome Nitride Coatings for Applications in Plastics Processing
- Using Computational Fluid Dynamics to Investigate the Flow of a Viscous Fluid in a Cavity with Oscillating Boundaries
- Simulation of Flow in an Intermeshing Modular Counter-rotating Twin Screw Extruder: Non-Newtonian and Non-Isothermal Behavior
- Reactive Extrusion
- Bulk and Dispersed Phase Polymerization of Urethane in Twin Screw Extruders
- Die Extrusion
- Wire Coating by Drawdown of an Extruded Annular Melt
- Fibers and Films
- Structure Development in Melt Spinning Polypropylene-EPM Blends and Dynamically Vulcanized Polyolefin TPEs
- Simulation of Blown-Film Process Taking Account of Cooling-air Effect
- Molding
- Analysis of Shrinkage Development of Injection Moulded PS Samples
- Optimization of the Weldline Strength in Gas-assist Injection Molded Thermoplastic
- Injection Velocity Control Using A Self-tuning Adaptive Controller
