Dendritic structure formation of magnesium alloys for the manipulation of corrosion properties: Part 1 – microstructure

Articles in the same Issue

1. Contents
2. Contents
3. Original Contributions
4. Dendritic structure formation of magnesium alloys for the manipulation of corrosion properties: Part 1 – microstructure
5. The influence of twinning on plastic constitutive description of a magnesium alloy
6. Effect of V and Zr microalloying, and heat treatment on microstructure and mechanical properties of secondary Al-7Si-3Cu-0.3Mg alloy
7. Effect of heat treatment on microstructure, hardening and plasticity of a commercial Al–Zn–Mg–Cu alloy
8. Microstructural evolution and mechanical properties of thixoformed 7075 aluminum alloy prepared by conventional and new modified SIMA processes
9. Hot torsion behavior of SP-700 near beta titanium alloy in single and dual phase regions
10. Effect of B₄C in Ti-6Al-4V matrix on workability behavior of powder metallurgy composites during cold upsetting
11. Synthesis of Ni/YSZ based anode and investigation of effect of PVA as pore-former upon porosity, microstructure and thermal behavior for potential use in solid oxide fuel cells (SOFCs)
12. The corrosion behavior of porous Ni–Cr–Fe alloy in 2 mol L⁻¹ alkaline solution
13. Short Communications
14. The grain growth in alumina compacts sintered under high pressure
15. DGM News
16. DGM News