Contents

Articles in the same Issue

1. Contents
2. Contents
3. Basic
4. Texture and microstructure evolution of ECAP processed AlMg1Mn0.14 alloy
5. Modelling grain refinement in fcc metals during equal-channel angular pressing by route “C”
6. Fabrication of high strength nanostructured aluminium alloys by hydrostatic extrusion
7. Comparison of the plastic strain distribution during equal-channel angular pressing (ECAP) using 2D and 3D FEM modeling
8. Deformation twins in ultrafine grained commercial aluminum
9. Compressive behaviour of ultrafine-grained AA6063T6 over a wide range of strains and strain rates
10. Grain refinement response during twist extrusion of an Al-0.13% Mg alloy
11. Preparation of NiO–LiFeO₂ solid solutions: the role of mechanical and thermal treatments
12. Applied
13. Fatigue strength and fracture behavior of steels with and without interstitial carbon at room temperature in air
14. The influence of Nd on the corrosion behavior of electroless-deposited Fe–P
15. Time-dependent directional solidification of binary Al–Cu alloys in the initial transient
16. Effect of V₂O₅ doping on the microstructure and local composition of textured Sr_0.4Ba_0.6Nb₂O₆ ceramics
17. Microstructure and mechanical properties of AZ91D alloy prepared by a semi-solid diecasting process
18. Development of SMD 32.768 kHz tuning fork type crystals
19. Notifications
20. DGM News