Editorial January 2011

Articles in the same Issue

1. Contents
2. Contents
3. Editorial
4. Editorial January 2011
5. Short Communications
6. Observation of stacking faults in a scanning electron microscope by electron channelling contrast imaging
7. Original Contributions
8. Experimental investigation and thermodynamic calculation of the Fe–Mg–Mn and Fe–Mg–Ni systems
9. Critical investigation of high temperature gas nitriding of a PM tool steel
10. Tracing the growth rate changes during vertical directional solidification by electrical resistance measurements
11. Microstructure and properties of hard magnetic FeCr30Co8 alloy subjected to plastic deformation by complex loading
12. Microstructural evolution through hot working of the single-phase and two-phase Ti-6Al-4V alloy
13. Tensile properties of ultrafine grained Mg-3%Al alloy studied at elevated temperature
14. Microstructural evolution and mechanical properties of Cu-10Cr-0.4Zr filamentary in-situ composites
15. Al–Fe alloy formation by aluminium underpotential deposition from AlCl₃ + NaCl melts on iron substrate
16. A new approach to monitoring thermal fatigue cracks in die casting moulds
17. The ability of cast composite technology to enhance ductility of wrought magnesium and alloys
18. Hot rolling of binary Ti–Nb alloys Part 1: evolution of microstructure and texture
19. Thermochemical investigations in the tin–phosphorus system^*
20. Luminescence properties of Tb³⁺-activated silicate glass scintillator
21. (Fe, Cr)₆Nb₆O_x phase of the filled Ti₂Ni type with × ± 0.75 in the quaternary Cr–Fe–Nb–O system
22. DGM News
23. DGM News