Article
Open Access
Investigation about the Manufacturing Technique of the Composite Corner Fitting Part
-
Peng Wang
,
Xavier Legrand
Published/Copyright:
June 17, 2014
Published Online: 2014-6-17
Published in Print: 2014-6-1
© Autex Research Journal
Articles in the same Issue
- Performance Study of Screen-Printed Textile Antennas after Repeated Washing
- Determination of Fabric Surface Resistance by Van Der Pauw Method in Case of Contacts Distant from the Sample Edge
- Comparative Investigation of Mechanical–Physical Characteristics of Biodegradable and Non-Degradable Yarns
- Antibacterial Properties of Functional Polyamide 6.6
- A Study on Electrical Performances and Lifetime of a Flexible Electrochromic Textile Device
- Effect of Geometry on Performance of Interlacer
- Footwear Use at Workplace and Recommendations for the Improvement of its Functionality and Hygiene
- Fabrication of Plga/Hap and Plga/Phb/Hap Fibrous Nanocomposite Materials for Osseous Tissue Regeneration
- Investigation about the Manufacturing Technique of the Composite Corner Fitting Part
Keywords for this article
Manufacture;
Weaving;
Textile Composite;
Forming;
3D Fabric;
Corner Fitting
Creative Commons
BY-NC-ND 3.0
Articles in the same Issue
- Performance Study of Screen-Printed Textile Antennas after Repeated Washing
- Determination of Fabric Surface Resistance by Van Der Pauw Method in Case of Contacts Distant from the Sample Edge
- Comparative Investigation of Mechanical–Physical Characteristics of Biodegradable and Non-Degradable Yarns
- Antibacterial Properties of Functional Polyamide 6.6
- A Study on Electrical Performances and Lifetime of a Flexible Electrochromic Textile Device
- Effect of Geometry on Performance of Interlacer
- Footwear Use at Workplace and Recommendations for the Improvement of its Functionality and Hygiene
- Fabrication of Plga/Hap and Plga/Phb/Hap Fibrous Nanocomposite Materials for Osseous Tissue Regeneration
- Investigation about the Manufacturing Technique of the Composite Corner Fitting Part
