Interferometric study of pyrite surface reactivity in acidic conditions
-
M. Pilar Asta
,
J.M. Soler
Abstract
Production of acid mine drainage (AMD) is in large part due to pyrite oxidation. The tie-in between environmental remediation and pyrite oxidation requires understanding pyrite oxidation in aqueous systems. In this study, ex-situ measurements using vertical scanning interferometry (VSI) were utilized to investigate pyrite surface reactivity under AMD conditions, such as pH 1 (HCl), an O2-saturated atmosphere, and room temperature, including (1) ex-situ measurements using vertical scanning interferometry (VSI) and (2) solution chemistry measurements using a flow reactor. In the former, two fragments were immersed in the acidic solution for 27 days at undersaturation with respect to pyrite. Weathered surfaces of pyrite that showed surface history (e.g., existence of terraces, steps, etch pits, and non-uniform surface roughness) were selected to examine surface topography changes with time.
Based on the VSI measurements, the reaction mechanism includes the formation and coalescence of etch pits leading to overall surface retreat. This result is consistent with the stepwave model that predicts that, under sufficiently high undersaturation (i.e., ΔG < ΔGcrit), pit opening and generation of stepwaves are mechanisms that control mineral dissolution. Surface reactivity was not uniform over the entire surface, yielding surface regions with a considerable variety of dissolution rates that ranged from 1.7 × 10−7 mol/(m2·s) to lower than 2 × 10−11 mol/(m2·s). The overall pyrite dissolution rate calculated over the explored surface was 2.8 × 10−9 mol/(m2·s), which agrees very well with the absolute rate measured [3.1 × 10−9 mol/(m2·s)].
Based on the release of Fe in the flow experiment and normalizing with the geometric surface area, the steady-state pyrite dissolution rate obtained was 7.2 ± 1.5 × 10−9 mol/(m2·s), i.e., a factor of about 2 higher than that determined by VSI. Collectively, these rates also agree with pyrite dissolution rates obtained by bulk dissolution measurements. These results highlight (1) “local” dissolution rates vary widely over mineral surfaces at the short range scale from nano- to millimeter lengths; (2) inferred dissolution rates that are usually based on topographic changes on rather small (micrometer-scale size) surface regions are not necessarily representative of rates under field conditions; and (3) BET surface area and geometric surface area associated with reactive surface area and used to normalize the pyrite dissolution rates yield a variation in rate that ranges from 6.3 × 10−11 to 7.2 ± 1.5 × 10−9 mol/(m2·s).
© 2015 by Walter de Gruyter Berlin/Boston
Articles in the same Issue
- Compositional variability and crystal structural features of guanacoite
- Interferometric study of pyrite surface reactivity in acidic conditions
- White mica domain formation: A model for paragonite, margarite, and muscovite formation during prograde metamorphism
- High-pressure phase transitions in MgSiO3 orthoenstatite studied by atomistic computer simulation
- Time-resolved synchrotron powder X-ray diffraction study of magnetite formation by the Fe(III)-reducing bacterium Geobacter sulfurreducens
- Low-temperature calorimetric and magnetic data for natural end-members of the axinite group
- Temperature derivatives of elastic wave velocities in plagioclase (An51±1) above and below the order-disorder transition temperature
- Disordered silica with tridymite-like structure in the Twiggs clay
- Crystal structures of synthetic melanotekite (Pb2Fe2Si2O9), kentrolite (Pb2Mn2Si2O9), and the aluminum analogue (Pb2Al2Si2O9)
- Structure and reactivity of synthetic Co-substituted goethites
- The crystal chemistry of Fe-bearing sphalerites: An infrared spectroscopic study
- Effects of hydration on the structure and compressibility of wadsleyite, β-(Mg2SiO4)
- Metastability of sillimanite relative to corundum and quartz in the kyanite stability field: Competition between stable and metastable reactions
- Diffusion, discontinuous precipitation, metamorphism, and metasomatism: The complex history of South African upper-mantle symplectites
- Thermal behavior of a Ti-rich phlogopite from Mt. Vulture (Potenza, Italy): An in situ X-ray single-crystal diffraction study
- The high-pressure behavior of an Al- and Fe-rich natural orthopyroxene
- High-pressure phase relation of MnSiO3 up to 85 GPa: Existence of MnSiO3 perovskite
- Linking Mössbauer and structural parameters in elbaite-schorl-dravite tourmalines
- Synchrotron powder X-ray diffraction study of the structure and dehydration behavior of palygorskite
- Maskelynite-hosted apatite in the Chassigny meteorite: Insights into late-stage magmatic volatile evolution in martian magmas
- Eskolaite associated with diamond from the Udachnaya kimberlite pipe, Yakutia, Russia
- Lakebogaite, CaNaFe23+H(UO2)2(PO4)4(OH)2(H2O)8, a new uranyl phosphate with a unique crystal structure from Victoria, Australia
- Letter. Crystal structure and Raman spectrum of hydroxyl-bästnasite-(Ce), CeCO3(OH)
Articles in the same Issue
- Compositional variability and crystal structural features of guanacoite
- Interferometric study of pyrite surface reactivity in acidic conditions
- White mica domain formation: A model for paragonite, margarite, and muscovite formation during prograde metamorphism
- High-pressure phase transitions in MgSiO3 orthoenstatite studied by atomistic computer simulation
- Time-resolved synchrotron powder X-ray diffraction study of magnetite formation by the Fe(III)-reducing bacterium Geobacter sulfurreducens
- Low-temperature calorimetric and magnetic data for natural end-members of the axinite group
- Temperature derivatives of elastic wave velocities in plagioclase (An51±1) above and below the order-disorder transition temperature
- Disordered silica with tridymite-like structure in the Twiggs clay
- Crystal structures of synthetic melanotekite (Pb2Fe2Si2O9), kentrolite (Pb2Mn2Si2O9), and the aluminum analogue (Pb2Al2Si2O9)
- Structure and reactivity of synthetic Co-substituted goethites
- The crystal chemistry of Fe-bearing sphalerites: An infrared spectroscopic study
- Effects of hydration on the structure and compressibility of wadsleyite, β-(Mg2SiO4)
- Metastability of sillimanite relative to corundum and quartz in the kyanite stability field: Competition between stable and metastable reactions
- Diffusion, discontinuous precipitation, metamorphism, and metasomatism: The complex history of South African upper-mantle symplectites
- Thermal behavior of a Ti-rich phlogopite from Mt. Vulture (Potenza, Italy): An in situ X-ray single-crystal diffraction study
- The high-pressure behavior of an Al- and Fe-rich natural orthopyroxene
- High-pressure phase relation of MnSiO3 up to 85 GPa: Existence of MnSiO3 perovskite
- Linking Mössbauer and structural parameters in elbaite-schorl-dravite tourmalines
- Synchrotron powder X-ray diffraction study of the structure and dehydration behavior of palygorskite
- Maskelynite-hosted apatite in the Chassigny meteorite: Insights into late-stage magmatic volatile evolution in martian magmas
- Eskolaite associated with diamond from the Udachnaya kimberlite pipe, Yakutia, Russia
- Lakebogaite, CaNaFe23+H(UO2)2(PO4)4(OH)2(H2O)8, a new uranyl phosphate with a unique crystal structure from Victoria, Australia
- Letter. Crystal structure and Raman spectrum of hydroxyl-bästnasite-(Ce), CeCO3(OH)
