Biopyribole evolution during tremolite synthesis from dolomite and quartz in CO2-H2O fluid
-
Krassimir N. Bozhilov
,
Daniel Brownstein
Abstract
A series of experiments with and without sample retreatment was performed on a starting mixture of dolomite plus quartz at 0.5 GPa and 600 °C in a CO2-H2O fluid with a mole fraction of CO2 of 0.2 for durations up to 582 h. The initial reaction of dolomite and quartz led to rapid formation of talc and calcite instead of tremolite and calcite by the intended reaction: 5 dolomite + 8 quartz + H2O = tremolite + 3 calcite + 7 CO2. With continued treatment, the talc + calcite + quartz assemblage gradually reacts to form increasing amounts of tremolite and diopside with the eventual loss of quartz and nearly complete loss of talc.
The detailed structure of the amphibole and the nature of the Mg enrichment were revealed using AEM analysis of individual amphibole crystals. The most abundant defects are triple-chain chain multiplicity faults (CMFs), which appear as isolated lamellae with single periodicity in short-duration experiments and increasingly as groups of lamellae with variable multiplicity and periodicity in longer duration experiments and especially in a long-duration experiment without retreatment. In this latter experiment, a calcian clinojimthompsonite domain extending 15 unit cells along the b axis was observed. The sample after 582 h and five retreatments shows, on average, 3.5% true solid solution with Mg expressed as the Mg-cummingtonite (MC) component after correction for the presence of CMFs. This sample is thought to most closely approach the equilibrium composition for the amphibole. The sample after 250 h with three retreatments has about 10%, whereas that after 582 h without retreatment has 0.6% MC component, the latter having a relatively high density of CMFs. This study affirms the importance that precursor non-amphibole biopyriboles play in the formation of tremolitic amphibole.
© 2015 by Walter de Gruyter Berlin/Boston
Articles in the same Issue
- Single-crystal FTIR and X-ray study of vishnevite, ideally [Na6(SO4)][Na2(H2O)2](Si6Al6O24)
- Crystallographic texture and microstructure of terebratulide brachiopod shell calcite: An optimized materials design with hierarchical architecture
- High-temperature phase relations and topological constraints in the quaternary system MgO-Al2O3-SiO2-Cr2O3: An experimental study
- Tilt and buckling modes, and acoustic anisotropy in layers with post-perovskite connectivity
- Optical absorption study of natural garnets of almandine-skiagite composition showing intervalence Fe2+ + Fe3+ → Fe3+ + Fe2+ charge-transfer transition
- Deriving formation constants for aqueous metal complexes from XANES spectra: Zn2+ and Fe2+ chloride complexes in hypersaline solutions
- Birnessite polytype systematics and identiÞ cation by powder X-ray diffraction
- Improved measurement of fission-track annealing in apatite using c-axis projection
- Improved modeling of fission-track annealing in apatite
- Intercalibration of FTIR and SIMS for hydrogen measurements in glasses and nominally anhydrous minerals
- Order and miscibility in the otavite–magnesite solid solution
- An infrared investigation of the otavite-magnesite solid solution
- Partitioning of calcium, magnesium, and transition metals between olivine and melt governed by the structure of the silicate melt at ambient pressure
- The geometric effects of VFe2+ for VMg substitution on the crystal structures of the grandidierite-ominelite series
- The iron oxidation state of garnet by electron microprobe: Its determination with the flank method combined with major-element analysis
- Gram-Charlier development of the atomic displacement factors into mineral structures: The case of samsonite, Ag4MnSb2S6
- Superstructure of Challis mordenite with doubled monoclinic unit cell
- Biopyribole evolution during tremolite synthesis from dolomite and quartz in CO2-H2O fluid
- The evolution of diamond morphology in the process of dissolution: Experimental data
- The pearceite-polybasite group of minerals: Crystal chemistry and new nomenclature rules
- Determination of layer stacking microstructures and intralayer transition of illite polytypes by high-resolution transmission electron microscopy (HRTEM)
- Structural behavior of Al3+ in peralkaline, metaluminous, and peraluminous silicate melts and glasses at ambient pressure
- The crystal structure of ingersonite, Ca3Mn2+Sb45+O14, and its relationships with pyrochlore
- Chemical composition, statistical analysis of the unit cell, and electrostatic modeling of the structure of Al-saturated chlorite from metamorphosed rocks
- XANES study of the oxidation state of Cr in lower mantle phases: Periclase and magnesium silicate perovskite
- Crystal chemistry of hydration in aluminous orthopyroxene
Articles in the same Issue
- Single-crystal FTIR and X-ray study of vishnevite, ideally [Na6(SO4)][Na2(H2O)2](Si6Al6O24)
- Crystallographic texture and microstructure of terebratulide brachiopod shell calcite: An optimized materials design with hierarchical architecture
- High-temperature phase relations and topological constraints in the quaternary system MgO-Al2O3-SiO2-Cr2O3: An experimental study
- Tilt and buckling modes, and acoustic anisotropy in layers with post-perovskite connectivity
- Optical absorption study of natural garnets of almandine-skiagite composition showing intervalence Fe2+ + Fe3+ → Fe3+ + Fe2+ charge-transfer transition
- Deriving formation constants for aqueous metal complexes from XANES spectra: Zn2+ and Fe2+ chloride complexes in hypersaline solutions
- Birnessite polytype systematics and identiÞ cation by powder X-ray diffraction
- Improved measurement of fission-track annealing in apatite using c-axis projection
- Improved modeling of fission-track annealing in apatite
- Intercalibration of FTIR and SIMS for hydrogen measurements in glasses and nominally anhydrous minerals
- Order and miscibility in the otavite–magnesite solid solution
- An infrared investigation of the otavite-magnesite solid solution
- Partitioning of calcium, magnesium, and transition metals between olivine and melt governed by the structure of the silicate melt at ambient pressure
- The geometric effects of VFe2+ for VMg substitution on the crystal structures of the grandidierite-ominelite series
- The iron oxidation state of garnet by electron microprobe: Its determination with the flank method combined with major-element analysis
- Gram-Charlier development of the atomic displacement factors into mineral structures: The case of samsonite, Ag4MnSb2S6
- Superstructure of Challis mordenite with doubled monoclinic unit cell
- Biopyribole evolution during tremolite synthesis from dolomite and quartz in CO2-H2O fluid
- The evolution of diamond morphology in the process of dissolution: Experimental data
- The pearceite-polybasite group of minerals: Crystal chemistry and new nomenclature rules
- Determination of layer stacking microstructures and intralayer transition of illite polytypes by high-resolution transmission electron microscopy (HRTEM)
- Structural behavior of Al3+ in peralkaline, metaluminous, and peraluminous silicate melts and glasses at ambient pressure
- The crystal structure of ingersonite, Ca3Mn2+Sb45+O14, and its relationships with pyrochlore
- Chemical composition, statistical analysis of the unit cell, and electrostatic modeling of the structure of Al-saturated chlorite from metamorphosed rocks
- XANES study of the oxidation state of Cr in lower mantle phases: Periclase and magnesium silicate perovskite
- Crystal chemistry of hydration in aluminous orthopyroxene
