Article Open Access

Stress analysis of single fiber composites using an elastoplastic shear-lag approach

  • EMAIL logo and
Published/Copyright: March 1, 2012
Download Article (PDF)
Become an author with De Gruyter Brill
Submit Manuscript Author Information
Science and Engineering of Composite Materials
From the journal Science and Engineering of Composite Materials Volume 19 Issue 1

Published Online: 2012-03-01
Published in Print: 2012-03-01

©2012 by Walter de Gruyter Berlin Boston

Articles in the same Issue

  1. Original Articles
  2. Modeling self-healing efficiency on cracks due to unhydrated cement nuclei in cementitious materials: splitting crack mode
  3. Numerical simulation of cementitious granular materials
  4. Durability properties of concrete reinforced with steel-polypropylene hybrid fibers
  5. Strengthening of brick infilled RC frames with different aspect ratios by means of CFRP overlays
  6. Effect of montmorillonite as additive on the properties of cement-based composites
  7. Mechanical properties and microstructure of 2.5D (shallow bend-joint) quartzf/silica composites by silicasol-infiltration-sintering
  8. Stress analysis of single fiber composites using an elastoplastic shear-lag approach
  9. A comparative hardness study of Al-Si/AlB2 and Al-Si/AlB12 composites
  10. Study of corrosion behavior of sprayed zinc-aluminum (ZAZA) coatings in a marine environment
  11. A generalized Gompertz model of reliability-dependent hazard rate for composites under cyclic stresses
  12. Preparation and thermal properties of flame retardant phthalonitrile/epoxy blends
  13. Masthead
  14. Masthead
https://doi.org/10.1515/secm.2011.0067
Keywords for this article
elastoplastic shear-lag analysis; fiber break; stress analysis
Creative Commons
BY-NC-ND 3.0

Articles in the same Issue

  1. Original Articles
  2. Modeling self-healing efficiency on cracks due to unhydrated cement nuclei in cementitious materials: splitting crack mode
  3. Numerical simulation of cementitious granular materials
  4. Durability properties of concrete reinforced with steel-polypropylene hybrid fibers
  5. Strengthening of brick infilled RC frames with different aspect ratios by means of CFRP overlays
  6. Effect of montmorillonite as additive on the properties of cement-based composites
  7. Mechanical properties and microstructure of 2.5D (shallow bend-joint) quartzf/silica composites by silicasol-infiltration-sintering
  8. Stress analysis of single fiber composites using an elastoplastic shear-lag approach
  9. A comparative hardness study of Al-Si/AlB2 and Al-Si/AlB12 composites
  10. Study of corrosion behavior of sprayed zinc-aluminum (ZAZA) coatings in a marine environment
  11. A generalized Gompertz model of reliability-dependent hazard rate for composites under cyclic stresses
  12. Preparation and thermal properties of flame retardant phthalonitrile/epoxy blends
  13. Masthead
  14. Masthead
Downloaded on 13.4.2026 from https://www.degruyterbrill.com/document/doi/10.1515/secm.2011.0067/html
Scroll to top button