Frontmatter

Articles in the same Issue

1. Frontmatter
2. Original articles
3. Effect of polyarylene ether nitrile on the curing behaviors and properties of bisphthalonitrile
4. Consolidation and swell characteristics of dispersive soils stabilized with lime and natural zeolite
5. Aging hardening characteristic and electrical conductivity of Cu-Cr-Zr-Mo in situ composite
6. Modeling cement hydration by connecting a nucleation and growth mechanism with a diffusion mechanism. Part II: Portland cement paste hydration
7. Unsaturated flow characteristics in dual-scale fibre fabrics at one-dimensional constant flow rate
8. Crushing analysis and crashworthiness optimization design of reinforced regular hexagon honeycomb sandwich panel
9. Effects on the microstructure and mechanical properties of Sn-0.7Cu lead-free solder with the addition of a small amount of magnesium
10. Investigation of chip seal performance under cold climate conditions
11. 2D macro-mechanical FE simulations for machining unidirectional FRP composite: the influence of damage models
12. The grinding surface characteristics and evaluation of particle-reinforced aluminum silicon carbide
13. Influence of tire cord layers and arrangement direction on mechanical properties and vibration isolation of chloroprene rubber composite materials reinforced with polyester tire cord
14. Material parameter identification in functionally graded structures using isoparametric graded finite element model
15. Improved impact response of hygrothermally conditioned carbon/epoxy woven composites
16. An experimental study on the effect of length and orientation of embedded FBG sensors on the signal properties under fatigue loading
17. Experimental impact study on unidirectional glass-carbon hybrid composite laminates
18. Design and performance analysis of small-sized multiband microstrip patch antenna on custom-made biopolymer substrate
19. Surface modification of Ti alloys with WC-TiB₂-reinforced laser composite coatings
20. The machinability of Al/B₄C composites produced by hot pressing based on reinforcing the element ratio
21. Effect of thermal exposure on the microstructure of the interface in a Gr_f/Al composite