Article
Licensed
Unlicensed
Requires Authentication
A new start for Journal of Polymer Engineering
Published/Copyright:
April 20, 2011
Published Online: 2011-04-20
Published in Print: 2011-04-01
©2011 by Walter de Gruyter Berlin New York
You are currently not able to access this content.
You are currently not able to access this content.
Articles in the same Issue
- Publisher’s Note
- A new start for Journal of Polymer Engineering
- News
- Implementing a new manuscript submission system
- Original Articles
- Model for the hydrodynamic dispersion of agglomerates incorporating thermoresponsive additives
- Preparation and properties of PLA/long alkyl chain modified multi-walled carbon nanotubes nanocomposites
- Insights into the slip flow phenomena encountered during in-mold coating (IMC) of plastic parts
- Physical properties of biaxially oriented PA6 film for simultaneous stretching and sequential processing
- Synthesis and solution behaviors of star hydrophobically modified acrylamide copolymers
- Melt temperature learning control of injection molding process based on CMAC neural network
- Numerical analysis of mixing performance of mixing section in pin-barrel single-screw extruder
- New process technology for high volume production of composites
Articles in the same Issue
- Publisher’s Note
- A new start for Journal of Polymer Engineering
- News
- Implementing a new manuscript submission system
- Original Articles
- Model for the hydrodynamic dispersion of agglomerates incorporating thermoresponsive additives
- Preparation and properties of PLA/long alkyl chain modified multi-walled carbon nanotubes nanocomposites
- Insights into the slip flow phenomena encountered during in-mold coating (IMC) of plastic parts
- Physical properties of biaxially oriented PA6 film for simultaneous stretching and sequential processing
- Synthesis and solution behaviors of star hydrophobically modified acrylamide copolymers
- Melt temperature learning control of injection molding process based on CMAC neural network
- Numerical analysis of mixing performance of mixing section in pin-barrel single-screw extruder
- New process technology for high volume production of composites
