Glass Formation in Mechanically Alloyed 3d-Transıtion Metal-Tantalum Alloys

Articles in the same Issue

1. Inhalt
2. Aufsätze
3. Glass Formation in Mechanically Alloyed 3d-Transıtion Metal-Tantalum Alloys
4. Thermodynamic Analysıs and Evaluation of the Nitrogen Solubility in Liquid Nb and Fe-Nb Alloys
5. Phase Equilibria in the System In-Ir-As at 600 °C
6. Room Temperature Slip in a Molybdenum Bierystal Prepared by Means of Secondary Reecrystallization
7. Thermomechanical Treatment of Spinodal Cu-32Ni-2Cr Alloy
8. Elevated Temperature Properties of Short-fiber Reinforced AlSi9Cu3 Produced by Pressure Die-casting
9. Fallstudie zur werkstoffmechanischen Modellierung der pulvermetallurgisch hergestellten Aluminiumlegierung AlZn11Mg3Cul.5Mn0.6
10. The Influence of Powder Particle Size on the Mechanical Properties of Two Rapidly Solidified Al-Fe-Ce Alloys Part 1: Powder Characteristics
11. The Influence of Powder Particle Size on the Mechanical Properties of Two Rapidly Solidified Al-Fe-Ce Alloys Part 2: Mechanical Properties
12. Plastizität und Bruch eines austenitischferritischen Duplexstahles
13. Characterization of Low-cycle Fatigue and Creep-fatigue Induced Damage in a 316L Stainless Steel
14. Fatigue Behaviour of Rope Eutectoid Steel Wires
15. Mitteilungen der Deutschen Gesellschaft für Materialkunde e. V.
16. Pasonen
17. Buchbesprechungen
18. VERANSTALTUNGEN
19. Impressum