Heat Flow and Solidification in a Metal Mould

Articles in the same Issue

1. Elektronenmikroskopische Untersuchung von y/y’-Phasengrenzen in der einkristallinen Nickelbasislegierung SRR 99 nach Anlaßversuchen
2. Fractal Analysis of Grain Boundaries in Hot-worked Poly-crystals
3. Strain Rate Sensitivity of Zn-Cu Single Crystals
4. Cracking of Cementite Particles and its Influences on the Development of the Rolling Texture in Low Carbon Steels
5. Assessment of the Thermodynamic Properties of the Ni-Co System
6. Untersuchungen zur thermischen Stabilität binärer Übergangsmetallgläser
7. Spinel Deoxidation Equilibrium in the Co-Mn-Al-O System — Experiment and Modeling
8. The Effect of Thermal Cycling on the Kinetics of Cellular Precipitation in a Cu-In Alloy
9. Discontinuous Coarsening of the Cellular Precipitates in a Ni-Sn Alloy
10. A Comparative Study of the Microstructure, Mechanical Properties and Fracture Behaviour of Melt-Spun Ribbon and Ingot Metallurgy Al-3 wt.% Li Alloy
11. Heat Flow and Solidification in a Metal Mould
12. Addendum and Erratum
13. Gesellschaftsnachrichten