Article
Publicly Available
Frontmatter
Published/Copyright:
April 29, 2017
Published Online: 2017-4-29
Published in Print: 2017-4-28
© 2017 Walter de Gruyter GmbH, Berlin/Boston
Articles in the same Issue
- Frontmatter
- Research Articles
- The Kirkendall Effect and Multi-component Diffusion Simulations
- Effect of Z Values on the Microstructure and Mechanical Properties of Post-sintered Reaction Bonded β-SiAlON
- Effects of Ti–Mg Complex Inclusions on Acicular Ferrite Nucleation
- Hot Deformation Behavior and Constitutive Modeling of Alloy 800H Considering Effectsof Strain
- Microstructure and Properties of W–Cu Composite/Fe-Based Powder Alloy Vacuum Brazed Joint with Different Filler Metals
- Mechanical Properties and Microstructures of Ni20Cr Micro-wires with Abnormal Plastic Deformation
- Material Flow Behavior of Refill Friction Stir Spot Welded LY12 Aluminum Alloy
- Study on High-Temperature Mechanical Properties of Low-Carbon Fe-Mn-Si-Al TWIP Steel
- The Effects of Molding Materials on Microstructure and Wear Behavior of A356 Alloy
- Special Issue: Cutting Edge of Computer Simulation of Solidification, casting and refining
- Decarburization and Inclusion Removal Process in Single Snorkel Vacuum Degasser
- Discussion on Modeling Capability for Macrosegregation
- The Model Analysis of Inclusion Moving in the Swirl Flow Zone Sourcing from the Inner-Swirl-Type Turbulence Controller in Tundish
- Mathematical Modeling of Liquid Slag Layer Fluctuation and Slag Droplets Entrainment in a Continuous Casting Mold Based on VOF-LES Method
Articles in the same Issue
- Frontmatter
- Research Articles
- The Kirkendall Effect and Multi-component Diffusion Simulations
- Effect of Z Values on the Microstructure and Mechanical Properties of Post-sintered Reaction Bonded β-SiAlON
- Effects of Ti–Mg Complex Inclusions on Acicular Ferrite Nucleation
- Hot Deformation Behavior and Constitutive Modeling of Alloy 800H Considering Effectsof Strain
- Microstructure and Properties of W–Cu Composite/Fe-Based Powder Alloy Vacuum Brazed Joint with Different Filler Metals
- Mechanical Properties and Microstructures of Ni20Cr Micro-wires with Abnormal Plastic Deformation
- Material Flow Behavior of Refill Friction Stir Spot Welded LY12 Aluminum Alloy
- Study on High-Temperature Mechanical Properties of Low-Carbon Fe-Mn-Si-Al TWIP Steel
- The Effects of Molding Materials on Microstructure and Wear Behavior of A356 Alloy
- Special Issue: Cutting Edge of Computer Simulation of Solidification, casting and refining
- Decarburization and Inclusion Removal Process in Single Snorkel Vacuum Degasser
- Discussion on Modeling Capability for Macrosegregation
- The Model Analysis of Inclusion Moving in the Swirl Flow Zone Sourcing from the Inner-Swirl-Type Turbulence Controller in Tundish
- Mathematical Modeling of Liquid Slag Layer Fluctuation and Slag Droplets Entrainment in a Continuous Casting Mold Based on VOF-LES Method
