Article
Open Access
Reactive Interdiffusion: A Method for Making Composition Graded Metal-ceramic Composites
-
S. N. S. Reddy
and
G. Rajitha
Published/Copyright:
May 11, 2012
Received: 2011-07-12
Accepted: 2011-12-17
Published Online: 2012-05-11
Published in Print: 2012-04-05
©2012 by Walter de Gruyter Berlin Boston
Articles in the same Issue
- Masthead
- Reactive Interdiffusion: A Method for Making Composition Graded Metal-ceramic Composites
- Effect of Process Variables on the Formation of Streak Defects on Anodized Aluminum Extrusions: An Overview
- Effect of Temperature Dropping During Reheat Treatments on GTD-111 Microstructure
- Influence of Withdrawing Rates on Elements Segregation and Creep Properties of A Single Crystal Nickel-Based Superalloy
- The Effect of CdS/organic Nanostructure as Additive on the Thermal Stability of ABS Polymer
- Carbothermal Reductive Upgrading of a Bauxite Ore Using Microwave Radiation
- Improvement in wear and corrosion resistance of AISI 1020 steel by high velocity oxy-fuel spray coating containing Ni-Cr-B-Si-Fe-C
- Single-Source Molecular Precursor for Synthesis of CdS Nanoparticles and Nanoflowers
- High-temperature Oxidation Resistance of Al2O3-Au Laminated Composite Coating Prepared on TiAl-based Alloy
- Contact Strength and Cracking of Laminar Ceramics
- An Anomalous Internal Oxidation of Dilute Cu-Ni Alloys at 800 °C under 1 atm O2
- Preparation and Structural Characterizations of Titania Slag
Keywords for this article
Composition-graded composites;
metal-ceramic composite;
diffusion;
interfaces;
microstructure
Creative Commons
BY-NC-ND 3.0
Articles in the same Issue
- Masthead
- Reactive Interdiffusion: A Method for Making Composition Graded Metal-ceramic Composites
- Effect of Process Variables on the Formation of Streak Defects on Anodized Aluminum Extrusions: An Overview
- Effect of Temperature Dropping During Reheat Treatments on GTD-111 Microstructure
- Influence of Withdrawing Rates on Elements Segregation and Creep Properties of A Single Crystal Nickel-Based Superalloy
- The Effect of CdS/organic Nanostructure as Additive on the Thermal Stability of ABS Polymer
- Carbothermal Reductive Upgrading of a Bauxite Ore Using Microwave Radiation
- Improvement in wear and corrosion resistance of AISI 1020 steel by high velocity oxy-fuel spray coating containing Ni-Cr-B-Si-Fe-C
- Single-Source Molecular Precursor for Synthesis of CdS Nanoparticles and Nanoflowers
- High-temperature Oxidation Resistance of Al2O3-Au Laminated Composite Coating Prepared on TiAl-based Alloy
- Contact Strength and Cracking of Laminar Ceramics
- An Anomalous Internal Oxidation of Dilute Cu-Ni Alloys at 800 °C under 1 atm O2
- Preparation and Structural Characterizations of Titania Slag
