Article
Open Access
Parameter Measurement of Biaxial Braided Composite Preform Based on Phase Congruency
-
,
Published/Copyright:
February 23, 2019
Published Online: 2019-02-23
Published in Print: 2019-03-01
© 2019 Zhitao Xiao et al., published by Sciendo
Articles in the same Issue
- Effects of Chemical Structure of Silicone Polyethers Used as Fabric Softener Additives on Selected Utility Properties of Cotton Fabric
- Parameter Measurement of Biaxial Braided Composite Preform Based on Phase Congruency
- Physical Mechanical Properties of Medical Socks Proposed for Diabetic Foot Syndrome Sampled from the Market
- Two-Stage Discrete Mechanical Modelin Three-Dimensional Spacefor Garmentsimulation
- Modification of Surface of Basalt Fabric on Protecting Against High Temperatures by the Method of Magnetron Sputtering
- Enhancement of Hydrostatic Resistance and Mechanical Performance of Waterproof Breathable Laminated Fabrics
- Analysis of Changes in Fiber Density Distribution in a Cotton Combed Spinning System Using Modified Regulation of the Sliver Draft
- Rapid Parametric Human Modeling in 3D Garment Simulation
- Wicking Behaviors of Ring and Compact-Siro Ring Spun Yarns with Different Twists
- Effect of the Position of Defined Local Defect on the Mechanical Performance of Carbon-Fiber-Reinforced Plastics
- Comparison of Mechanical and Thermal Comfort Properties of Tencel Blended with Regenerated Fibers and Cotton Woven Fabrics
- Modal–Cotton Fibre Blend Ratio and Ring Frame Parameter Optimisation Through the Taguchi Method
Keywords for this article
2D biaxial braided composite preform;
parameter measurement;
surface braiding angle;
pitch length;
phase congruency
Creative Commons
BY-NC-ND 4.0
Articles in the same Issue
- Effects of Chemical Structure of Silicone Polyethers Used as Fabric Softener Additives on Selected Utility Properties of Cotton Fabric
- Parameter Measurement of Biaxial Braided Composite Preform Based on Phase Congruency
- Physical Mechanical Properties of Medical Socks Proposed for Diabetic Foot Syndrome Sampled from the Market
- Two-Stage Discrete Mechanical Modelin Three-Dimensional Spacefor Garmentsimulation
- Modification of Surface of Basalt Fabric on Protecting Against High Temperatures by the Method of Magnetron Sputtering
- Enhancement of Hydrostatic Resistance and Mechanical Performance of Waterproof Breathable Laminated Fabrics
- Analysis of Changes in Fiber Density Distribution in a Cotton Combed Spinning System Using Modified Regulation of the Sliver Draft
- Rapid Parametric Human Modeling in 3D Garment Simulation
- Wicking Behaviors of Ring and Compact-Siro Ring Spun Yarns with Different Twists
- Effect of the Position of Defined Local Defect on the Mechanical Performance of Carbon-Fiber-Reinforced Plastics
- Comparison of Mechanical and Thermal Comfort Properties of Tencel Blended with Regenerated Fibers and Cotton Woven Fabrics
- Modal–Cotton Fibre Blend Ratio and Ring Frame Parameter Optimisation Through the Taguchi Method
