Skip to main content
Article
Licensed
Unlicensed Requires Authentication

Experimental Research on Air Flow through Liner Holes

  • and
Published/Copyright: September 1, 1986
Become an author with De Gruyter Brill
Author Information
International Journal of Turbo and Jet Engines
From the journal International Journal of Turbo and Jet Engines Volume 3 Issue 2-3

Published Online: 1986-09

©2011 by Walter de Gruyter GmbH & Co.

Articles in the same Issue

  1. CONTENTS
  2. In-Flight Short Field Landing Investigations on a Combat Aircraft with Thrust Reverser
  3. Distribution of Mean Concentration, Dropsize and Velocity, and Size-Velocity Correlations in the Spray of an Air-assist Nozzle
  4. Combined Influence of Unsteady Free Stream Velocity and Free Stream Turbulence on Stagnation Point Heat Transfer
  5. Experimental Research on Air Flow through Liner Holes
  6. Measurement of Swirling Flow Field Using the Single-Slanted Hot-Wire Technique
  7. Emissions from Enclosed Swirl Stabilised Premixed Flames
  8. Conical Grid Plate Flame Stabilizers: Stability and Emissions for Liquid Fuels
  9. Conical Grid Plate Flame Stabilizers for Combustor Primary Zones
  10. A Preliminary Study of Annular Diffusers with Constant Diameter Outer Walls (Suitable for Turbine Exits)
  11. An Experimental and Theoretical Investigation of an Uncentralized Squeeze-Film Damper Bearing and the Test Results on a Jet Engine
  12. Effect of Air Pressure upon Spray Angle/Width Characteristics of Simplex Pressure Swirl Atomizers
  13. A Two-Dimensional Finite Element Stress Analysis of Radial Impellers
  14. Modified Characteristic Method for Calculation of Supersonic S2 Flow Field in Compressor
  15. Fuel Effects on Gas Turbine Combustion
  16. Transpiration Cooling: Contribution of Film Cooling to the Overall Cooling Effectiveness
https://doi.org/10.1515/TJJ.1986.3.2-3.125

Articles in the same Issue

  1. CONTENTS
  2. In-Flight Short Field Landing Investigations on a Combat Aircraft with Thrust Reverser
  3. Distribution of Mean Concentration, Dropsize and Velocity, and Size-Velocity Correlations in the Spray of an Air-assist Nozzle
  4. Combined Influence of Unsteady Free Stream Velocity and Free Stream Turbulence on Stagnation Point Heat Transfer
  5. Experimental Research on Air Flow through Liner Holes
  6. Measurement of Swirling Flow Field Using the Single-Slanted Hot-Wire Technique
  7. Emissions from Enclosed Swirl Stabilised Premixed Flames
  8. Conical Grid Plate Flame Stabilizers: Stability and Emissions for Liquid Fuels
  9. Conical Grid Plate Flame Stabilizers for Combustor Primary Zones
  10. A Preliminary Study of Annular Diffusers with Constant Diameter Outer Walls (Suitable for Turbine Exits)
  11. An Experimental and Theoretical Investigation of an Uncentralized Squeeze-Film Damper Bearing and the Test Results on a Jet Engine
  12. Effect of Air Pressure upon Spray Angle/Width Characteristics of Simplex Pressure Swirl Atomizers
  13. A Two-Dimensional Finite Element Stress Analysis of Radial Impellers
  14. Modified Characteristic Method for Calculation of Supersonic S2 Flow Field in Compressor
  15. Fuel Effects on Gas Turbine Combustion
  16. Transpiration Cooling: Contribution of Film Cooling to the Overall Cooling Effectiveness
Downloaded on 11.5.2026 from https://www.degruyterbrill.com/document/doi/10.1515/TJJ.1986.3.2-3.125/html?lang=en
Scroll to top button