Article
Licensed
Unlicensed
Requires Authentication
TABLE OF CONTENTS
Published/Copyright:
June 1, 2008
Published Online: 2008-06
©2011 by Walter de Gruyter GmbH & Co.
You are currently not able to access this content.
You are currently not able to access this content.
Articles in the same Issue
- TABLE OF CONTENTS
- Experimental Investigations on Work Roll Grinding of D2 Steel for the Selection of Optimal Parameters
- Optimum Selection of Machining Parameters in Electrochemical Machining using Response Surface Methodology
- Fractal Dimension Modeling of Surface Profile and Optimization in EDM Using Response Surface Method
- Reverse Engineering on Port Cores of a Cylinder Head Using Digitizing Technique
- Prediction of Tensile Strength of Friction Stir Welded A356 Cast Aluminium Alloy Using Response Surface Methodology and Artificial Neural Network
- Multi-Objective Scheduling of Jobs, Automated Guided Vehicles and Automated Storage/Retrieval System in Flexible Manufacturing System
- Superplastic Behavior of a Ti-Al-Mn Alloy
- Modelling of EDM Process Parameters for Machining Stainless Steel using Copper Electrodes
- A Case Study on the Premature Failure of a Cooling Water Pump Shaft
- Effects of Minimum Quantity Lubrication (MQL) on Chip Formation Mode, Tool Wear, and Surface Roughness in Turning AISI-1040 Steel with Uncoated Carbide Tool
Articles in the same Issue
- TABLE OF CONTENTS
- Experimental Investigations on Work Roll Grinding of D2 Steel for the Selection of Optimal Parameters
- Optimum Selection of Machining Parameters in Electrochemical Machining using Response Surface Methodology
- Fractal Dimension Modeling of Surface Profile and Optimization in EDM Using Response Surface Method
- Reverse Engineering on Port Cores of a Cylinder Head Using Digitizing Technique
- Prediction of Tensile Strength of Friction Stir Welded A356 Cast Aluminium Alloy Using Response Surface Methodology and Artificial Neural Network
- Multi-Objective Scheduling of Jobs, Automated Guided Vehicles and Automated Storage/Retrieval System in Flexible Manufacturing System
- Superplastic Behavior of a Ti-Al-Mn Alloy
- Modelling of EDM Process Parameters for Machining Stainless Steel using Copper Electrodes
- A Case Study on the Premature Failure of a Cooling Water Pump Shaft
- Effects of Minimum Quantity Lubrication (MQL) on Chip Formation Mode, Tool Wear, and Surface Roughness in Turning AISI-1040 Steel with Uncoated Carbide Tool
