Experimental Investigations on Work Roll Grinding of D2 Steel for the Selection of Optimal Parameters

Articles in the same Issue

1. TABLE OF CONTENTS
2. Experimental Investigations on Work Roll Grinding of D2 Steel for the Selection of Optimal Parameters
3. Optimum Selection of Machining Parameters in Electrochemical Machining using Response Surface Methodology
4. Fractal Dimension Modeling of Surface Profile and Optimization in EDM Using Response Surface Method
5. Reverse Engineering on Port Cores of a Cylinder Head Using Digitizing Technique
6. Prediction of Tensile Strength of Friction Stir Welded A356 Cast Aluminium Alloy Using Response Surface Methodology and Artificial Neural Network
7. Multi-Objective Scheduling of Jobs, Automated Guided Vehicles and Automated Storage/Retrieval System in Flexible Manufacturing System
8. Superplastic Behavior of a Ti-Al-Mn Alloy
9. Modelling of EDM Process Parameters for Machining Stainless Steel using Copper Electrodes
10. A Case Study on the Premature Failure of a Cooling Water Pump Shaft
11. Effects of Minimum Quantity Lubrication (MQL) on Chip Formation Mode, Tool Wear, and Surface Roughness in Turning AISI-1040 Steel with Uncoated Carbide Tool