Article
Licensed
Unlicensed
Requires Authentication
The Fabrication and Heat-treating of Cu-based Alloy for Shape Memory Plates
-
Vanja Asanović,
Published/Copyright:
March 1, 2006
Published Online: 2006-03
©2011 by Walter de Gruyter GmbH & Co.
You are currently not able to access this content.
You are currently not able to access this content.
Articles in the same Issue
- TABLE OF CONTENTS
- Performance of Copper and Aluminum Electrodes During EDM of Stainless Steel and Carbide
- Mathematical Modeling for Study of Parametric Influence on Bead Height, Bead Width and Depth of Heat Affected Zone of Submerged Arc Bead-on-Plate Weldment
- An Experimental and Statistical Study on the Effect of Trepanning Tool and Twist Drill on Forces and Hole Quality in Machining GFRP Composites
- A Model for Cutting Tool Wear Estimation
- Modeling of Centrifugal Casting of Aluminum Alloy Components
- The Fabrication and Heat-treating of Cu-based Alloy for Shape Memory Plates
Articles in the same Issue
- TABLE OF CONTENTS
- Performance of Copper and Aluminum Electrodes During EDM of Stainless Steel and Carbide
- Mathematical Modeling for Study of Parametric Influence on Bead Height, Bead Width and Depth of Heat Affected Zone of Submerged Arc Bead-on-Plate Weldment
- An Experimental and Statistical Study on the Effect of Trepanning Tool and Twist Drill on Forces and Hole Quality in Machining GFRP Composites
- A Model for Cutting Tool Wear Estimation
- Modeling of Centrifugal Casting of Aluminum Alloy Components
- The Fabrication and Heat-treating of Cu-based Alloy for Shape Memory Plates
