Article
Licensed
Unlicensed
Requires Authentication
Process Control for Three Quality Classes and Three Repair Actions
-
Gauri Shankar
Published/Copyright:
March 10, 2010
Abstract
In this paper a production process with a uni-variate quality characteristic is considered where the output is classified in three quality classes: good, marginal and bad. The process is subject to quality deterioration and, therefore, it is periodically monitored and according to the observed result a decision for one of four courses of action is made. The control procedure is represented by means of a GERT network and subsequently analysed using the so-called W-functions. Finally, the behaviour of the control scheme is investigated by some numerical examples.
Published Online: 2010-03-10
Published in Print: 2004-October
© Heldermann Verlag
You are currently not able to access this content.
You are currently not able to access this content.
Articles in the same Issue
- Maintenance Policies with Minimal Repair
- Analysis of a Repairable System Subjected To Multiple Modes of Failure
- Run Length Variability and Three Sigma Control Limits
- Estimating Structural Reliability in the Presence of Covariates Via Bayesian Methods
- A Note on Point Estimation of System Reliability Exemplified for the Log-Logistic Distribution
- A Note on Testing Exponentiality Against New Better Than Used of Specified Age
- Measurement Procedures for Improving the Variability Function
- The Least Cost Testing Sequence Problem
- Process Control for Three Quality Classes and Three Repair Actions
- Standardisation of Flour Testing in Alveograph NG
- A Problem Called ISO 2859-1 Sampling Procedures for Inspection by Attributes - Part 1
Articles in the same Issue
- Maintenance Policies with Minimal Repair
- Analysis of a Repairable System Subjected To Multiple Modes of Failure
- Run Length Variability and Three Sigma Control Limits
- Estimating Structural Reliability in the Presence of Covariates Via Bayesian Methods
- A Note on Point Estimation of System Reliability Exemplified for the Log-Logistic Distribution
- A Note on Testing Exponentiality Against New Better Than Used of Specified Age
- Measurement Procedures for Improving the Variability Function
- The Least Cost Testing Sequence Problem
- Process Control for Three Quality Classes and Three Repair Actions
- Standardisation of Flour Testing in Alveograph NG
- A Problem Called ISO 2859-1 Sampling Procedures for Inspection by Attributes - Part 1
