Chapter
Licensed
Unlicensed
Requires Authentication
6. Double-Tool Turning
-
R. Kalidasan
You are currently not able to access this content.
You are currently not able to access this content.
Chapters in this book
- Frontmatter I
- Preface V
- About the editor VI
- Contents VII
- List of contributing authors XI
- 1. The Principle of Minimum Strain Energy to Fracture of the Work Material and Its Application in Modern Cutting Technologies 1
- 2. Energy Consumption Optimization in Machining Processes 36
- 3. Machining with High-Pressure Cooling 60
- 4. Effect of Machining on the Fatigue Life of Steels 76
- 5. FEM Analysis and ANN Modeling for Optimizing Machinability Indicators during Dry Longitudinal Turning of Ti–6Al–4V ELI Alloy 95
- 6. Double-Tool Turning 119
- 7. Effect of Electrical Resistivity on the Electrical Discharge Machining Process 143
- Index 171
Chapters in this book
- Frontmatter I
- Preface V
- About the editor VI
- Contents VII
- List of contributing authors XI
- 1. The Principle of Minimum Strain Energy to Fracture of the Work Material and Its Application in Modern Cutting Technologies 1
- 2. Energy Consumption Optimization in Machining Processes 36
- 3. Machining with High-Pressure Cooling 60
- 4. Effect of Machining on the Fatigue Life of Steels 76
- 5. FEM Analysis and ANN Modeling for Optimizing Machinability Indicators during Dry Longitudinal Turning of Ti–6Al–4V ELI Alloy 95
- 6. Double-Tool Turning 119
- 7. Effect of Electrical Resistivity on the Electrical Discharge Machining Process 143
- Index 171
