Abstract
Phase separation and phase diagram in the Fe-rich corner of the Fe –Al–V alloy system were investigated by means of transmission electron microscopy, scanning electron microscopy and energy-dispersive X-ray spectroscopy. Phase separation into disordered A2 and ordered L21 phases was found in a wide composition range in the Fe-rich corner at 923 K, 973 K and 1023 K, and their tie-lines were almost parallel to the direction connecting the Fe corner with the center of the Gibbs triangle. In addition to the A2 + L21 phase separation, phase separation into B2 and L21 phases was also observed at 1023 K at the side of Fe –Al binary system.
-
We would like to thank Mr. S. Aoki and Mr. T. Shikama for their helps with the experiments.
References
[1] M. Doi, T. Miyazaki, in: S.D. Antolovich, T.W. Strusrud, R.A. MacKay, D.L. Anton, T. Khan, R.D. Kissinger, D.L. Klarstrom (Eds.), Superalloys 1992, The Minerals, Metals & Materials Society, p. 537.Search in Google Scholar
[2] M. Fährmann, E. Fährmann, O. Paris, P. Fratzl, T.M. Pollock, in: R.D. Kissinger, D.J. Deye, D.L. Anton, A.D. Cetel, M.V. Nathal, T.M. Pollock, D.A. Woodford (Eds.), Superalloys 1996, The Minerals, Metals & Materials Society, p. 191.Search in Google Scholar
[3] M. Doi, T. Miyazaki: J. Mater. Sci. 27 (1992) 6291.10.1007/BF00576274Search in Google Scholar
[4] H. Masumoto, T. Yamamoto: J. Japan Inst. Metals 1 (1937) 127.10.2320/jinstmet1937.1.3_127Search in Google Scholar
[5] Y. Nishino, C. Kumada, S. Asano: Scripta Mater. 36 (1997) 461.10.1016/S1359-6462(96)00395-8Search in Google Scholar
[6] M.G. Mendiratta, S.K. Elers, H.A. Lipsitt: Metall. Trans. A 18 (1987) 509.10.1007/BF02649468Search in Google Scholar
[7] T.A. Hyde, S.H. Sellers, J.K. Wright, R.N. Wright: Scripta Metall. Mater. 30 (1994) 113.10.1016/0956-716X(94)90368-9Search in Google Scholar
[8] P.Z. Zhao, T. Kozakai, T. Miyazaki: J. Japan Inst. Metals 53 (1989) 266.10.2320/jinstmet1952.53.3_266Search in Google Scholar
[9] D.E., Okpalugo, J.G. Booth, C.A. Faunce: J. Phys. F: Met. Phys. 15 (1985) 681.10.1088/0305-4608/15/3/020Search in Google Scholar
[10] G.Y. Guo, F.A. Botton, Y. Nishino: J. Phys. Condensed Matter. 10 (1998) L119.10.1088/0953-8984/10/8/002Search in Google Scholar
[11] Z. Horita, T. Sano, M. Nemoto: ISIJ Intern. 29 (1989) 179.10.2355/isijinternational.29.179Search in Google Scholar
[12] C. Bichara, G. Inden: Scripta Metall. Mater. 25 (1991) 2607.10.1016/0956-716X(91)90077-ESearch in Google Scholar
© 2004 Carl Hanser Verlag, München
Articles in the same Issue
- Frontmatter
- Articles Basic
- Phase formation, thermal stability and crystallization behavior of Cu47Ti33Zr11Ni8X1 (X = Fe, Si, Sn, Pb) bulk glassy alloys
- Thermodynamic reassessment of the Al–V system
- Experimental investigation of the equilibrium composition of titanium carbonitride and analysis using thermodynamic modelling
- A model for 3-D study of rearrangement in liquid phase sintering
- Measurement and calculation of surface tension of undercooled liquid Fe-20 wt.% Cu alloy
- Phase equilibria in iron-rich Fe–Al–V ternary alloy system
- Articles Applied
- Evolution of microstructure during creep in gamma Ti–52Al at 1100 K and high applied stresses
- Effect of tempering on the chemical and phase composition of MxCy precipitates in low carbon chromium-molybdenum-vanadium steel
- Phase changes in superaustenitic steels after long-term annealing
- 3D and microstructural analysis of the chip formation during high speed cutting of C45E (AISI 1045)
- Elevated temperature friction and wear behavior of SiC-reinforced copper matrix composites
- On the microstructure developed in as-cast and homogenized 7010 aluminium alloy containing scandium
- Notifications/Mitteilungen
- Personal/Personelles
- Conferences/Konferenzen
Articles in the same Issue
- Frontmatter
- Articles Basic
- Phase formation, thermal stability and crystallization behavior of Cu47Ti33Zr11Ni8X1 (X = Fe, Si, Sn, Pb) bulk glassy alloys
- Thermodynamic reassessment of the Al–V system
- Experimental investigation of the equilibrium composition of titanium carbonitride and analysis using thermodynamic modelling
- A model for 3-D study of rearrangement in liquid phase sintering
- Measurement and calculation of surface tension of undercooled liquid Fe-20 wt.% Cu alloy
- Phase equilibria in iron-rich Fe–Al–V ternary alloy system
- Articles Applied
- Evolution of microstructure during creep in gamma Ti–52Al at 1100 K and high applied stresses
- Effect of tempering on the chemical and phase composition of MxCy precipitates in low carbon chromium-molybdenum-vanadium steel
- Phase changes in superaustenitic steels after long-term annealing
- 3D and microstructural analysis of the chip formation during high speed cutting of C45E (AISI 1045)
- Elevated temperature friction and wear behavior of SiC-reinforced copper matrix composites
- On the microstructure developed in as-cast and homogenized 7010 aluminium alloy containing scandium
- Notifications/Mitteilungen
- Personal/Personelles
- Conferences/Konferenzen