DGM conferences

Articles in the same Issue

1. Frontmatter
2. Articles/Aufsätze
3. Mechanical properties of Cu/In – 48 Sn/Cu diffusion-soldered joints
4. Effect of ultrasonic (cavitation) treatment of the melt on the microstructure evolution during solidification of aluminum alloy ingots
5. Computer simulation of the long-range diffusional transformation based on the postulated principle of maximum dissipation rate of Gibbs energy
6. Kinetics of growth of intermetallics in the Cu–Sn system
7. Atomic composition of the metastable β^″ phase precipitate in an Al –Mg–Si alloy
8. Interfacial tension of metastable immiscible alloys: a novel measurement concept
9. On the kinetics of the initial oxidation of iron and iron nitride
10. Synthesis and characterisation of MgAlON
11. Kinetic studies of oxidation of MgAlON and a comparison of the oxidation behaviour of AlON, MgAlON, O’SiAlON–ZrO₂, and BN–ZCM ceramics
12. Study on warm rolling of AISI 1015 carbon steel
13. Experimental study on elastic modulus and damping capacity of woodceramics
14. Texture development during cold rolling of unidirectionally solidified Al–Al₃Ni alloy
15. Wear behavior of A356/M₇C₃ and A356/SiC particulate metal matrix composites
16. Microstructural characterization and microhardness of rapidly solidified Al –Ce alloys
17. Effect of quenching rate on the microstructure of rapidly solidified Al –Sr alloys
18. The protective mechanism of the native rust layer on Cr-containing steels exposed to marine atmosphere
19. Notifications/Mitteilungen
20. Personen
21. DGM conferences