Synthesis and characterization of modified poly(methyl methacrylate)/Al₂O₃nanocomposites as denture resins

Articles in the same Issue

1. Original Articles
2. Mechanical and microstructural properties of polystyrene based composites: positron lifetime spectroscopic and DSC studies
3. Complex permittivity measurements of RF plasma polymerized polyterpenol organic thin films employing split post dielectric resonator
4. Fluctuation-induced forces in critical crosslinked polymer blends
5. Chemical and physical properties of self-crosslinked poly(vinyl chloride)/nitrile rubber nanocomposites prepared by melt-mixing process
6. An effective tool to characterize adhesion at the interface of binary polymer blends: a free volume study
7. Characterization of interfacial adhesion in binary polymer blends: a new approach based on positron lifetime study
8. Microwave-assisted ionic liquid phase synthesis of phthalonitrile polymers
9. Nano- and microcomplexes of biopolymer carrageenans and dodecylammonium chloride
10. Performance enhancement of polysulfone ultrafiltration membrane by blending with polyurethane hydrophilic polymer
11. Electrostrictive polymer composite for energy harvesters and actuators
12. Dynamic mechanical behavior of phenoxy/carbon nanotube composites: assessment through different functionalization
13. Thermodynamic analysis of phase separation of a thermoplastic in a variant epoxy/monoamine-diamine system: influence of epoxy molecular structure
14. Synthesis and characterization of modified poly(methyl methacrylate)/Al₂O₃nanocomposites as denture resins
15. A study on the potential of NCF thermoplastic composites for use in aeronautic structural applications
16. Electromagnetic response of polymer composites with quasi-spherical nanocarbon inclusions: theory below the percolation threshold
17. Processing and characterization of titanium dioxide composites from vegetable oil resource
18. Thermo-mechanical properties and thermal conductivity of CdS-trans-polyisoprene, polymer nanocomposite
19. Ultrasound assisted process of PA6/clay nanocomposites: mechanical, rheological and barrier properties
20. A comparative study of polyelectrolyte induced metachromasy
21. Synthesis, characterization and corrosion protection properties of polyN-(p-bromophenyl)-2-methacrylamide-co-glycidyl methacrylate on low nickel stainless steel
22. Performance of high temperature superconducting ceramic/thermoplastic polymer composites
23. Review
24. Polythiophene composites: a review of selected applications
25. Numerical and experimental studies on extrudate swell of branched polyethylene through axisymmetric and planar dies
26. Applicability of time temperature superposition principle to an immiscible blend of polyphenyleneoxide and polyamide
27. Study on the effect of processing conditions on the impact strength of PP/SEBS/PC ternary blends using Taguchi experimental analysis
28. Role of important parameters in ring opening polymerization of polylactide
29. Kinetic parameters estimation of ring-opening poly(lactic acid) polymerization by modeling and simulation
30. Aromatic polyurethanes: the effect of hard segment and chain structure on their properties
31. Development of integrated bioenergy devices for the improvement in the quality of life of poor people
32. Mechanical and thermal properties of polymer micro- and nanocomposites
33. Structural and electrical characterization of plasticized PVA: AgI polymer electrolyte
34. Study of mechanical behavior of Kevlar/polypropylene hybrid yarns and their composites
35. Water transport, FTIR, and morphology characterizations of novel biodegradable blends based on poly(3-hydroxybutyrate)
36. Structural investigation of conducting polythiophene composites
37. Microfluidic biochip injection moulded using a patterned SU-8/Si mould insert
38. Modifications of polymers by additives and irradiations and their characterizations
39. Experimental investigations and optimization of processibility of sheet moulding compound