IMPRESSUM

Articles in the same Issue

1. CONTENTS
2. Materials Testing
3. FACHBEITRÄGE
4. New alloy development from modified cast Ni-base superalloy GTD-111 with additions of Al, Ni and/or Co prepared by vacuum arc melting process
5. Enhancing a twist beam suspension system conceptual design using population-based optimization methods
6. Influence of alumina whisker or nano-carbon contents on the microstructure and mechanical properties of CuZrTiAlNi refractory high entropy alloy composites
7. Mechanical properties and fatigue behavior of CO₂ laser beam welded armor steel joints
8. Microstructure and properties of a laser cladded NiCrBSi alloy coating
9. Dynamic response and damage assessment of spherical robot GFRP spherical shell under low velocity impact
10. Influence of temperature on structural-phase changes and physical properties of ceramics on the basis of aluminum oxide and silicon
11. Effect of the temperature gradient on hot cracking susceptibility for electron beam welding Alloy 247 LC
12. Effect of copper or carbon fiber addition to the 3D printing of polylactid samples
13. Theoretical evaluation of abrasive wear behavior of B₄C/ FeCrC coating layer evaluated by a Taguchi approach
14. Effect of the welding parameters on the surface morphology of resistance spot welded AISI 304 stainless steel joints
15. Sine-cosine optimization algorithm for the conceptual design of automobile components
16. Design and optimization of an electromechanical actuator for the latch of a foldable vehicle seat
17. Design and analysis of a pressure vessel according to EU 2014/29
18. BEZUGSQUELLEN
19. IMPRESSUM