Article
Licensed
Unlicensed
Requires Authentication
Personal/Personelles
Published/Copyright:
January 7, 2022
Published Online: 2022-01-07
© 2006 Carl Hanser Verlag, München
You are currently not able to access this content.
You are currently not able to access this content.
Articles in the same Issue
- Contents
- Phase separation in Si–(B)–C–N polymer-derived ceramics
- Solidification curves for commercial Mg alloys obtained from heat-transfer modeled DTA experiments
- Thermodynamic assessment of the Mg–Nd system
- Solid-state reaction in Ni/Si multilayered films, characterized by magneto-optical and optical spectroscopies
- Phase diagram of the Co–Cu–Ti system at 850 °C
- Effects of an electric field applied during the solution heat treatment of the Al–Mg –Si–Cu alloy AA6111 on the subsequent natural aging kinetics and tensile properties
- Fabrication and electrical sliding wear of graphitic Cu–Cr–Zr matrix composites
- Further results on creep behaviour of sand-cast Mg–2.8Nd–0.8Zn–0.5Zr–0.3Gd alloy at 0.56 to 0.61Tm under stresses 40 to 90 MPa
- On the creep resistance in cast Ni-base superalloys
- Formation, stability, and presence of magnesium nitride in magnesium recycling processes
- From waste to high strength alloy – recycling of magnesium chips
- Sigma phase formation and its effect on mechanical properties in the corrosion-resistant superalloy K44
- Personal/Personelles
- Press / Presse
- Contents
- Articles Basic
- Phase separation in Si–(B)–C–N polymer-derived ceramics
- Solidification curves for commercial Mg alloys obtained from heat-transfer modeled DTA experiments
- Thermodynamic assessment of the Mg–Nd system
- Solid-state reaction in Ni/Si multilayered films, characterized by magneto-optical and optical spectroscopies
- Phase diagram of the Co–Cu–Ti system at 850 °C
- Effects of an electric field applied during the solution heat treatment of the Al–Mg –Si–Cu alloy AA6111 on the subsequent natural aging kinetics and tensile properties
- Articles Applied
- Fabrication and electrical sliding wear of graphitic Cu–Cr–Zr matrix composites
- Further results on creep behaviour of sand-cast Mg–2.8Nd–0.8Zn–0.5Zr–0.3Gd alloy at 0.56 to 0.61Tm under stresses 40 to 90 MPa
- On the creep resistance in cast Ni-base superalloys
- Formation, stability, and presence of magnesium nitride in magnesium recycling processes
- From waste to high strength alloy – recycling of magnesium chips
- Sigma phase formation and its effect on mechanical properties in the corrosion-resistant superalloy K44
- Notifications/Mitteilungen
- Personal/Personelles
- Press / Presse
Articles in the same Issue
- Contents
- Phase separation in Si–(B)–C–N polymer-derived ceramics
- Solidification curves for commercial Mg alloys obtained from heat-transfer modeled DTA experiments
- Thermodynamic assessment of the Mg–Nd system
- Solid-state reaction in Ni/Si multilayered films, characterized by magneto-optical and optical spectroscopies
- Phase diagram of the Co–Cu–Ti system at 850 °C
- Effects of an electric field applied during the solution heat treatment of the Al–Mg –Si–Cu alloy AA6111 on the subsequent natural aging kinetics and tensile properties
- Fabrication and electrical sliding wear of graphitic Cu–Cr–Zr matrix composites
- Further results on creep behaviour of sand-cast Mg–2.8Nd–0.8Zn–0.5Zr–0.3Gd alloy at 0.56 to 0.61Tm under stresses 40 to 90 MPa
- On the creep resistance in cast Ni-base superalloys
- Formation, stability, and presence of magnesium nitride in magnesium recycling processes
- From waste to high strength alloy – recycling of magnesium chips
- Sigma phase formation and its effect on mechanical properties in the corrosion-resistant superalloy K44
- Personal/Personelles
- Press / Presse
- Contents
- Articles Basic
- Phase separation in Si–(B)–C–N polymer-derived ceramics
- Solidification curves for commercial Mg alloys obtained from heat-transfer modeled DTA experiments
- Thermodynamic assessment of the Mg–Nd system
- Solid-state reaction in Ni/Si multilayered films, characterized by magneto-optical and optical spectroscopies
- Phase diagram of the Co–Cu–Ti system at 850 °C
- Effects of an electric field applied during the solution heat treatment of the Al–Mg –Si–Cu alloy AA6111 on the subsequent natural aging kinetics and tensile properties
- Articles Applied
- Fabrication and electrical sliding wear of graphitic Cu–Cr–Zr matrix composites
- Further results on creep behaviour of sand-cast Mg–2.8Nd–0.8Zn–0.5Zr–0.3Gd alloy at 0.56 to 0.61Tm under stresses 40 to 90 MPa
- On the creep resistance in cast Ni-base superalloys
- Formation, stability, and presence of magnesium nitride in magnesium recycling processes
- From waste to high strength alloy – recycling of magnesium chips
- Sigma phase formation and its effect on mechanical properties in the corrosion-resistant superalloy K44
- Notifications/Mitteilungen
- Personal/Personelles
- Press / Presse