Texture and Anisotropy of Mechanical Properties in Titanium and Its Alloys

Articles in the same Issue

1. Impressum
2. INHALT
3. Aufsätze
4. Texture and Anisotropy of Mechanical Properties in Titanium and Its Alloys
5. Effect of Fe Content on Recrystallization Textures in Al-5%Mg Alloys
6. Radiation-Enhanced Self-Diffusion in a-Iron
7. Properties of Point Defects and Diffusion of the B2 FeAl Alloy Calculated by a Modified Analytic EAM Model
8. Thermodynamic Reassessment of the La-Ni System
9. Thermodynamic Assessment of the Zr-Au System
10. Tetragonal Distortion Induced {101} Twinning and Structural Modulation of yMn Phase in a Mn-20% Cu Alloy
11. Onset of Microstructural Instability in a Fully Lamellar Ti-46.5 at.% Al-4 at.% (Cr,Nb,Ta,B) Alloy during Short-term Creep
12. The Effect of Crystallographic Structure of Pure Metals on the Relation between their Specific Heat Content between Room Temperature and the Melting Point and the Magnitude of Some Mechanical Properties
13. Mossbauer and Infrared Spectroscopy Investigation on Glass Ceramics using Red Mud
14. Development of a Processing Map for the Hot Working of Ti-25Al-15Nb
15. Mechanisms of Hot Working in Extra-low Interstitial Grade TÌ-6A1-4V with Equiaxed (α + β) Microstructure
16. Variation in Tensile Ductility and Terminal Microstructure of the Binary Two-Phase Al-Cu Alloys at Elevated Temperatures
17. Study on Constitution and Wear Resistance of Nickel Phosphorus Alloy-Silicon Carbide Composite Coatings
18. Mitteilungen der Deutschen Gesellschaft für Materialkunde e. V.
19. Personen
20. Buchbesprechungen
21. DGM Fortbildung
22. Tagungskalender
23. Impressum