Experimental evaluation of a solar-assisted heat pump system as a hybrid thermal reactor for energy-efficient drying of agricultural biomass
-
Lohith Kumar P
,
Sunil Kumar M
Abstract
This study investigates the design, operation, and thermal performance of a solar-assisted heat pump dryer (SAHPD), conceptualized as a low-temperature hybrid thermal reactor for efficient drying of agricultural biomass. Focused on post-harvest processing of cardamom, the system integrates a vapor compression heat pump with a flat-plate solar collector, aiming to enhance energy recovery and improve moisture removal efficiency under tropical climatic conditions. Experiments were conducted in Karnataka, India, using a 10 kg batch of fresh cardamom subjected to drying over an 8-h period. The system was tested in three configurations: solar drying (SD), heat pump drying (HPD), and the integrated SAHPD mode. Key environmental parameters, including ambient temperature, relative humidity, and solar radiation (with peaks up to 870 W/m2), were recorded in real-time. Drying kinetics, energy efficiency, and total moisture loss were evaluated for each mode. The integrated SAHPD system demonstrated superior reactor performance, achieving approximately 80 % moisture removal (about 6 kg), while maintaining product quality and significantly reducing drying time. Compared to standalone modes, the SAHPD showed improved thermal utilization and operational stability under fluctuating weather conditions. The experimental results position the SAHPD as a promising thermal reactor configuration for sustainable, energy-efficient drying of moisture-laden biomass. This study contributes to the growing body of work on thermal reactor engineering for agricultural processes, supporting the development of environmentally responsible and process-intensified technologies in biomass conversion and post-harvest systems.
-
Research ethics: Not applicable.
-
Informed consent: Not applicable.
-
Author contributions: The authors have accepted responsibility for the entire content of this manuscript and approved its submission.
-
Use of Large Language Models, AI and Machine Learning Tools: No Tools were employed.
-
Conflict of interest: The authors state no conflict of interest.
-
Research funding: None declared.
-
Data availability: Not applicable.
References
[1] X Niu, et al.., “Thermodynamic analysis of supercritical Brayton cycles using CO2-based binary mixtures for solar power tower system application,” Energy, vol. 254, no. 1, p. 124286, 2022. https://doi.org/10.1016/j.energy.2022.124286.Search in Google Scholar
[2] R. Daghigh, M. H. Ruslan, Y. Sulaiman, and K. Sopian, “Review of solar assisted heat pump drying systems for agricultural and marine products,” Renew. Sustain. Energy Rev., vol. 14, pp. 2564–2579, 2010. https://doi.org/10.1016/j.rser.2010.04.004.Search in Google Scholar
[3] Z. Li, W. Wu, J. Wang, H. Wang, and X. Yu, “Effect of compressor speeds on performance of a closed loop heat pump drying system,” Appl. Therm. Eng., vol. 195, p. 117220, 2021. https://doi.org/10.1016/j.applthermaleng.2021.117220.Search in Google Scholar
[4] A. Singh, J. Sarkar, and R. R. Sahoo, “Comparative analyses on a batch-type heat pump dryer using low GWP refrigerants,” Food Bioprod. Process., vol. 117, pp. 1–13, 2019. https://doi.org/10.1016/j.fbp.2019.06.009.Search in Google Scholar
[5] B. Yesilata and M. A. Aktacir, “A simple moisture transfer model for drying of sliced foods,” Appl. Therm. Eng., vol. 29, pp. 748–752, 2009. https://doi.org/10.1016/j.applthermaleng.2008.03.048.Search in Google Scholar
[6] N Poyyamozhi, M. Arulprakasajothi, K. Elangovan, Y. Devarajan, and P. Chandrakumar, “Enhancing the summer efficiency of solar ponds through integration of paraffin wax and carbon soot nanoparticles,” J. Therm. Anal. Calorim., vol. 149, no. 23, pp. 14273–14288, 2024. https://doi.org/10.1007/s10973-024-13748-7.Search in Google Scholar
[7] M. Ssemwanga, E. Makule, and S. I. Kayondo, “Performance analysis of an improved solar dryer integrated with multiple metallic solar concentrators for drying fruits,” Sol. Energy, vol. 204, pp. 419–428, 2020. https://doi.org/10.1016/j.solener.2020.04.065.Search in Google Scholar
[8] H. S. EL-Mesery, A. I. EL-Seesy, Z. Hu, and Y. Li, “Recent developments in solar drying technology of food and agricultural products: a review,” Renew. Sustain. Energy Rev., vol. 157, p. 112070, 2022. https://doi.org/10.1016/j.rser.2021.112070.Search in Google Scholar
[9] M. Deymi-Dashtebayaz, A. Sulin, T. Ryabova, I. Sankina, M. Farahnak, and R. Nazeri, “Energy, exergoeconomic and environmental optimization of a cascade refrigeration system using different low GWP refrigerants,” J. Environ. Chem. Eng., vol. 9, p. 106473, 2021. https://doi.org/10.1016/j.jece.2021.106473.Search in Google Scholar
[10] M. Yao, et al.., “Analysis on characteristics and operation mode of direct solar collector coupled heat pump drying system,” Renew. Energy, vol. 206, pp. 223–238, 2023. https://doi.org/10.1016/j.renene.2023.02.016.Search in Google Scholar
[11] A. Nikitin, M. Farahnak, M. Deymi-Dashtebayaz, S. Muraveinikov, V. Nikitina, and R. Nazeri, “Effect of ice thickness and snow cover depth on performance optimization of ground source heat pump based on the energy, exergy, economic and environmental analysis,” Renew. Energy, vol. 185, pp. 1301–1317, 2022. https://doi.org/10.1016/j.renene.2021.12.132.Search in Google Scholar
[12] A. Singh, J. Sarkar, and R. Rekha Sahoo, “Experimentation on solar-assisted heat pump dryer: thermodynamic, economic and exergoeconomic assessments,” Sol. Energy, vol. 208, pp. 150–159, 2020. https://doi.org/10.1016/j.solener.2020.07.081.Search in Google Scholar
[13] L. Zou, Y. Liu, M. Yu, and J. Yu, “A review of solar assisted heat pump technology for drying applications,” Energy, vol. 283, p. 129215, 2023. https://doi.org/10.1016/j.energy.2023.129215.Search in Google Scholar
[14] A. Singh, J. Sarkar, and R. Sahoo, “Experimental energy, exergy, economic and exergoeconomic analyses of batch-type solar-assisted heat pump dryer,” Renew. Energy, vol. 156, 2020. https://doi.org/10.1016/j.renene.2020.04.100.Search in Google Scholar
[15] M. Arulprakasajothi, et al.., “An experimental investigation on winter heat storage in compact salinity gradient solar ponds with silicon dioxide particulates infused paraffin wax,” J. Energy Storage, vol. 82, p. 110503, 2024. https://doi.org/10.1016/j.est.2024.110503.Search in Google Scholar
[16] M. Deymi-Dashtebayaz and S. Valipour-Namanlo, “Thermoeconomic and environmental feasibility of waste heat recovery of a data center using air source heat pump,” J. Clean. Prod., vol. 219, pp. 117–126, 2019. https://doi.org/10.1016/j.jclepro.2019.02.061.Search in Google Scholar
[17] S. Maddah, M. Deymi-Dashtebayaz, and O. Maddah, “4E analysis of thermal recovery potential of industrial wastewater in heat pumps: an invisible energy resource from the Iranian casting industry sector,” J. Clean. Prod., vol. 265, p. 121824, 2020. https://doi.org/10.1016/j.jclepro.2020.121824.Search in Google Scholar
[18] M. Yahya, H. Fahmi, R. Hasibuan, and A. Fudholi, “Development of hybrid solar-assisted heat pump dryer for drying paddy,” Case Stud. Therm. Eng., vol. 45, p. 102936, 2023. https://doi.org/10.1016/j.csite.2023.102936.Search in Google Scholar
[19] M. Kuan, Y. Shakir, M. Mohanraj, Y. Belyayev, S. Jayaraj, and A. Kaltayev, “Numerical simulation of a heat pump assisted solar dryer for continental climates,” Renew. Energy, vol. 143, pp. 214–225, 2019. https://doi.org/10.1016/j.renene.2019.04.119.Search in Google Scholar
[20] J. Li, et al., “Study on heating performance of solar-assisted heat pump drying system under large temperature difference,” Sol. Energy, vol. 229, pp. 148–161, 2021. https://doi.org/10.1016/j.solener.2021.08.038.Search in Google Scholar
[21] H. Hasan Ismaeel and R. Yumrutaş, “Investigation of a solar assisted heat pump wheat drying system with underground thermal energy storage tank,” Sol. Energy, vol. 199, pp. 538–551, 2020. https://doi.org/10.1016/j.solener.2020.02.022.Search in Google Scholar
[22] M. Koşan, M. Demirtaş, M. Aktaş, and E. Dişli, “Performance analyses of sustainable PV/T assisted heat pump drying system,” Sol. Energy, vol. 199, pp. 657–672, 2020. https://doi.org/10.1016/j.solener.2020.02.040.Search in Google Scholar
[23] B. Nagappan, K. Alagu, Y. Devarajan, and D. B. Munuswamy, “Energy and exergy analysis of multi-temperature PCMs employed in a latent heat storage system and parabolic trough collector,” J. Non-Equilibrium Thermodyn., vol. 43, pp. 211–220, 2018. https://doi.org/10.1515/jnet-2017-0066.Search in Google Scholar
[24] M Arulprakasajothi, R. Santhanakrishnan, A. Saranya, and Y. Devarajan, “Augmentation of heat storage capacity of compact salinity gradient solar pond using dragon fruit extract coated magnesium powder and paraffin wax,” Therm. Sci. Eng. Prog., vol. 50, p. 102518, 2024. https://doi.org/10.1016/j.tsep.2024.102518.Search in Google Scholar
[25] M. Mohanraj, “Performance of a solar-ambient hybrid source heat pump drier for copra drying under hot-humid weather conditions,” Energy Sustain. Dev., vol. 23, pp. 165–169, 2014. https://doi.org/10.1016/j.esd.2014.09.001.Search in Google Scholar
[26] A. B. T. Loemba, B. Kichonge, and T. Kivevele, “Thermal performance and technoeconomic analysis of solar-assisted heat pump dryer integrated with energy storage materials for drying Cavendish banana (Musa acuminata),” J. Food Process. Preserv., vol. 2024, p. 7496826, 2024. https://doi.org/10.1155/2024/7496826.Search in Google Scholar
[27] K. Ma, Y. Yu, B. Yang, and J. Yang, “Demand-side energy management considering price oscillations for residential building heating and ventilation systems,” IEEE Trans. Ind. Inform., vol. 15, no. 8, pp. 4742–4752, 2019. https://doi.org/10.1109/TII.2019.2901306.Search in Google Scholar
[28] J. Yu, et al.., “Full recovery of brines at normal temperature with process-heat-supplied coupled air-carried evaporating separation (ACES) cycle,” npj Clean Water, vol. 7, no. 1, 2024. https://doi.org/10.1038/s41545-024-00430-6.Search in Google Scholar
© 2025 Walter de Gruyter GmbH, Berlin/Boston
