Non-destructive assessment of green density and moisture condition in plantation-grown radiata pine (Pinus radiata D. Don.) by increment core measurements
-
Julian Moreno Chan
Abstract
A novel protocol for non-destructive assessment of green density and moisture content via increment cores was validated for young (8–10 years) and mature trees (36 years) of radiata pine (Pinus radiata D. Don.). Initial procedures involved comparing 5- and 12-mm cores with fresh disks taken from young trees at breast height and felled during the winter, as well as methods for rehydrating the wood cores. Subsequently, the best method (12-mm cores) was validated with material collected in summer from both young and mature trees. The protocols developed require separate processing of sapwood and heartwood, and soaking the sapwood for 24 h to replace the moisture lost while coring. For young trees, bark-to-pith 12-mm cores accounted for between 64% and 66% of variation in green density of sapwood and between 51% and 72% of saturation percentage, as measured by destructively sampled disks. For mature trees, the average of two sides of 12-mm bark-to-bark cores accounted for 73% of variation in green density of sapwood, and 56% of saturation percentage as measured by destructive wedges. One or both sides of a bark-to-bark core accounted for between 72% and 80% of variation in whole-section green density, and between 70% and 79% of variation in sapwood percentage. The number of heartwood rings was better predicted from the average of two sides of the cores (R2 of 0.71). Whole-tree values (lower two logs) for sapwood green density and saturation were better predicted from the average of both sides of the bark-to-bark core (R2 of 0.76 and 0.57, respectively). Whole-tree values for whole-section green density could be predicted either by one side or two sides of the cores (R2 for 1 or 2 sides of 0.77 and 0.81). Finally, whole-tree sapwood volumetric percent was better predicted by the average of two sides of the cores (R2 of 0.81).
©2010 by Walter de Gruyter Berlin New York
Articles in the same Issue
- Original Papers
- Pre-extraction of hemicelluloses and subsequent ASA and ASAM pulping: Comparison of autohydrolysis and alkaline extraction
- Effect of drying and rewetting of wood on cellulose molecular packing
- Determination of native (wood derived) formaldehyde by the desiccator method in particleboards generated during panel production
- A computational study of pyrolysis reactions of lignin model compounds
- Energy reduction of refining by cellulases
- Macro- and micro-mechanical properties of red oak wood (Quercus rubra L.) treated with hemicellulases
- Acoustic emission measurements and lattice simulations of microfracture events in spruce
- Impact of organosilicon treatments on the wood-water relationship of solid wood
- Analysis of the water vapour sorption behaviour of Sitka spruce [Picea sitchensis (Bongard) Carr.] based on the parallel exponential kinetics model
- Effects of modification with glutaraldehyde on the mechanical properties of wood
- Effect of glutaraldehyde on water related properties of solid wood
- Creep behavior of bamboo under various desorption conditions
- Predicting the longitudinal modulus of elasticity of Sitka spruce from cellulose orientation and abundance
- Examination of the mode I critical stress intensity factor of wood obtained by single-edge-notched bending test
- Potential Brazilian wood species for bows of string instruments
- Non-destructive assessment of green density and moisture condition in plantation-grown radiata pine (Pinus radiata D. Don.) by increment core measurements
- Development of wood decay in wound-initiated discolored wood of eastern red cedar
- The effects of subthreshold loadings of tebuconazole, DDAC, and boric acid on wood decay by Postia placenta
- Short Notes
- New aspects of residual lignin isolation
- Personalia
- Horst H. Nimz celebrated his 80th birthday on April 21st, 2010
- Meetings
- Meetings
Articles in the same Issue
- Original Papers
- Pre-extraction of hemicelluloses and subsequent ASA and ASAM pulping: Comparison of autohydrolysis and alkaline extraction
- Effect of drying and rewetting of wood on cellulose molecular packing
- Determination of native (wood derived) formaldehyde by the desiccator method in particleboards generated during panel production
- A computational study of pyrolysis reactions of lignin model compounds
- Energy reduction of refining by cellulases
- Macro- and micro-mechanical properties of red oak wood (Quercus rubra L.) treated with hemicellulases
- Acoustic emission measurements and lattice simulations of microfracture events in spruce
- Impact of organosilicon treatments on the wood-water relationship of solid wood
- Analysis of the water vapour sorption behaviour of Sitka spruce [Picea sitchensis (Bongard) Carr.] based on the parallel exponential kinetics model
- Effects of modification with glutaraldehyde on the mechanical properties of wood
- Effect of glutaraldehyde on water related properties of solid wood
- Creep behavior of bamboo under various desorption conditions
- Predicting the longitudinal modulus of elasticity of Sitka spruce from cellulose orientation and abundance
- Examination of the mode I critical stress intensity factor of wood obtained by single-edge-notched bending test
- Potential Brazilian wood species for bows of string instruments
- Non-destructive assessment of green density and moisture condition in plantation-grown radiata pine (Pinus radiata D. Don.) by increment core measurements
- Development of wood decay in wound-initiated discolored wood of eastern red cedar
- The effects of subthreshold loadings of tebuconazole, DDAC, and boric acid on wood decay by Postia placenta
- Short Notes
- New aspects of residual lignin isolation
- Personalia
- Horst H. Nimz celebrated his 80th birthday on April 21st, 2010
- Meetings
- Meetings
