Article
Open Access
3D Buckling Analysis of Multidelaminated Composite Specimens
-
D. Tumino,
Published/Copyright:
September 1, 2007
Published Online: 2007-09
©2011 by Walter de Gruyter GmbH & Co.
Articles in the same Issue
- TABLE OF CONTENTS
- Prediction of Flexural Strength of RC Beams Strengthened with Carbon Fibre Reinforced Polymer
- 3D Buckling Analysis of Multidelaminated Composite Specimens
- Compressive and Gas Adsorptive Properties of Wood Activated Carbon Molded using a MgO Binder
- Prediction of Stiffness Degradation and Damage of Unidirectional GRP Composites Under Fatigue Cycles
- The Effect of Temperature Change on Flexural Strength of Polymer Concrete Composites with Polyester Resin During Hardening at Furnace Atmosphere
- Design and Manufacture of a Carbon Fibre Spindle Rotor Project results "Aerospin - Development of a highly precise spindle prototype"
- Interactions Due To Time Harmonic Inclined Load In Micropolar Thermoelastic Medium Possesing Cubic Symmetry Without Energy Dissipation
- Biomedical Coatings Prepared on Carbon/Carbon Composites
Creative Commons
BY-NC-ND 3.0
Articles in the same Issue
- TABLE OF CONTENTS
- Prediction of Flexural Strength of RC Beams Strengthened with Carbon Fibre Reinforced Polymer
- 3D Buckling Analysis of Multidelaminated Composite Specimens
- Compressive and Gas Adsorptive Properties of Wood Activated Carbon Molded using a MgO Binder
- Prediction of Stiffness Degradation and Damage of Unidirectional GRP Composites Under Fatigue Cycles
- The Effect of Temperature Change on Flexural Strength of Polymer Concrete Composites with Polyester Resin During Hardening at Furnace Atmosphere
- Design and Manufacture of a Carbon Fibre Spindle Rotor Project results "Aerospin - Development of a highly precise spindle prototype"
- Interactions Due To Time Harmonic Inclined Load In Micropolar Thermoelastic Medium Possesing Cubic Symmetry Without Energy Dissipation
- Biomedical Coatings Prepared on Carbon/Carbon Composites
