Production of Polymer Lenses Using Injection Moulding

Articles in the same Issue

1. CONTENTS
2. Production of Polymer Lenses Using Injection Moulding
3. Pet Film Extrusion with Degassing
4. New Demolding Concepts for the Injection Molding of Microstructures
5. Mechanical Design of Injection Moulded Parts made of Short-Fibre Reinforced Thermoplastics by Means of Integrative Simulation
6. The Injection Transfer Moulding Process in Comparison to the Multi-Cavity Injection Moulding
7. Properties and Manufacturing of Sandwich Parts with Phenolic Foam Cores
8. Process Analysis of Foam Injection Moulding with Physical Blowing Agents
9. Modelling the Dynamic Material Behaviour of Thermoplastics in the FEA
10. Improved Measurement and Modelling of the Fluidity of Compression Moulding Compounds
11. Developments in the Field of Microstructure Simulation Semi-Crystalline Thermoplastics
12. Simulation of the Solidification Kinetics and Crystallisation Kinetics at Injection Moulding
13. A Comparison of Sandwich Injection Moulding and Sandwich Injection-Compression Moulding
14. Consistent Simulation of Fibre Reinforced Thermoplastics: Forming Process and FE-Analysis of the Mechanical Behaviour
15. In-Mould Decorating of Continuous-Fibre Reinforced Thermoplastics
16. Application of the Fluid Injection Technique (GIT/WIT) at Bifurcated and Ring-Shaped Moulded Parts
17. Radial Profiling of Parison by the use of Flex Ring Technology
18. Back Foaming of Soft-Touch Decorative Films
19. New Developments for the Calculation of Fibre Reinforced Plastic Laminates - Nonlinear Material Properties and Gradual Failure
20. Estimating the Acoustic Behavior of Plastics Parts Under the Influence of Structure-Borne Sound